Win IT Exam with Last Dumps 2023


Cisco 350-501 Exam

Page 10/26
Viewing Questions 91 100 out of 253 Questions
38.46%

Question 91
A network engineer must enable the helper router to terminate the OSPF graceful restart process if it detects any changes in the LSA.Which command enables this feature?
A. nsf ietf helper disable
B. nsf cisco helper disable
C. nsf ietf helper strict-lsa-checking
D. nsf cisco enforce global

Question 92
Refer to the exhibit. A network engineer is implementing an OSPF configuration. Based on the output, which statement is true?
Image 350-501_92Q.png related to the Cisco 350-501 Exam
A. OSPFv3 does not run for IPv4 on FastEthernet0/0 until IPv6 routing is enabled on the router and IPv6 is enabled on interface FastEthernet0/0.
B. In the ospfv3 1 area 1 ipv4 command, area 0 must be configured instead of area 1.
C. OSPFv3 cannot be configured for IPv4; OSPFv3 works only for IPv6.
D. "IPv6 routing not enabled" is just an informational message and OSPFv3 runs for IPv4 on interface FastEthernet0/0 anyway.

Question 93
Refer to the exhibit. A network engineer is implementing a BGP protocol. Which effect of the local-as keyword in this configuration is true?
Image 350-501_93Q.png related to the Cisco 350-501 Exam
A. It enables peer 192.168.1.2 to establish a BGP relationship with R1 using AS 65012 without additional configuration.
B. It enables peer 192.168.1.2 to establish a BGP relationship with R1 using AS 65112 and the VPNv4 address family.
C. It enables peer 192.168.1.2 to establish a BGP relationship with R1 using AS 65012 and the VPNv4 address family.
D. It enables peer 192.168.1.2 to establish a BGP relationship with R1 using AS 65112 without additional configuration.

Question 94
Refer to the exhibit. Based on the show command output, which result is true after BGP session is established?
Image 350-501_94Q.png related to the Cisco 350-501 Exam
A. The IOS XR router advertises and accepts all routes to and from eBGP neighbor 192.168.2.2.
B. The IOS XR router advertises all routes to the neighbor 192.168.2.2, but it does not accept any routes from 192.168.2.2.
C. No routes are accepted from the neighbor 192.168.2.2, nor are any routes advertised to it.
D. The IOS XR router does not advertises any routes to the neighbor 192.168.2.2, but it accepts any routes from 192.168.2.2.

Question 95
Refer to the exhibit Which effect of this configuration is true?
Image 350-501_95Q.png related to the Cisco 350-501 Exam
A. The two routers fail to form a neighbor relationship because they have different IS-IS area types.
B. The two routers successfully form a neighbor relationship.
C. The two routers fail to form a neighbor relationship because the authentication configuration is missing.
D. The two routers fail to form a neighbor relationship because their system IDs are different.

Question 96
Refer to the exhibit. In which way does router R1 operate differently than router R2?
Image 350-501_96Q.png related to the Cisco 350-501 Exam
A. R1 sends LSA types 5 and 7, while R2 sends type 1, 2, and 7 LSAs.
B. R1 sends LSA type 2 only, while R2 sends type 1 and type 7 LSAs.
C. R1 sends LSA type 2 only and R2 sends LSA type 1 only.
D. R1 sends LSA types 1 and 2, while R2 sends type 1,2, and 7 LSAs.

Question 97
Refer to the exhibit. Which purpose of implementing NSF with this configuration is true?
Image 350-501_97Q.png related to the Cisco 350-501 Exam
A. The router uses NSF to handle RP switchover while allowing neighbor relationships to remain up.
B. The router uses NSF to reduce neighbor-relationship downtime during RP switchover.
C. The router uses NSF to load balance traffic on a routed EtherChannel.
D. The router uses NSF to load balance traffic between two links, with the primary link alternating every 90 seconds.

Question 98
Which task must be performed first to implement BFD in an IS-IS environment?
A. Configure BFD in an interface configuration mode.
B. Disable Cisco Express Forwarding on all interfaces running routing protocols other than IS-IS.
C. Configure all IS-IS routers as Level 2 devices.
D. Configure BFD under the IS-IS process.

Question 99
Which two IS-IS parameters must match before two Level 2 peers can form an adjacency? (Choose two.)
A. hello timer setting
B. authentication settings
C. area ID
D. system ID
E. MTU

Question 100
Refer to the exhibit. If RC is a stub router, which entry must be injected so that it will send traffic outside the OSPF domain?
Image 350-501_100Q.png related to the Cisco 350-501 Exam
A. more specific route
B. virtual link between RB and RC
C. sham link
D. default route



Premium Version