Win IT Exam with Last Dumps 2025

DRAG DROP -Drag and drop the LISP components on the left to the correct description on the right.
Select and Place:

Refer to the exhibit. Which command set must be added to permit and log all traffic that comes from 172.20.10.1 in interface GigabitEthernet0/1 without impacting the functionality of the access list?

A.

B.

C.

D.

Refer to the exhibit. A network engineer checks connectivity between two routers. The engineer can ping the remote endpoint but cannot see an ARP entry. Why is there no ARP entry?

A. When VRFs are used, ARP protocol must be enabled in each VRF.

B. The ping command must be executed in the global routing table.

C. Interface FastEthernet0/0 is configured in VRF CUST-A, so the ARP entry is also in that VRF.

D. When VRFs are used, ARP protocol is disabled in the global routing table.

Which option must be used to support a WLC with an IPv6 management address and 100 Cisco Aironet 2800 Series access points that will use DHCP to register?

A. 43

B. 52

C. 60

D. 82

Refer to the exhibit
Which configuration set implements Control Plane Policing for SSH and Telnet?

A.

B.

C.

D.

Refer to the exhibit. An engineer entered the command no spanning-tree bpduguard enable on interface Fa1/0/7. What is the effect of this command onFa1/0/7?

A. It remains in err-disabled state until the errdisable recovery cause failed-port-state command is entered in the global configuration mode

B. It remains in err-disabled state until the no shutdown command is entered in the interface configuration mode

C. It remains in err-disabled state until the shutdown/no shutdown command is entered in the interface configuration mode

D. It remains in err-disabled state until the spanning-tree portfast bpduguard disable command is entered in the interface configuration mode.

Which design principle states that a user has no access by default to any resource, and unless a resource is explicitly granted, it should be denied?

A. least privilege

B. fail-safe defaults

C. economy of mechanism

D. complete mediation

A customer wants to connect a device to an autonomous Cisco AP configured as a WGB. The WGB is configured properly: however, it fails to associate to aCAPWAP-enabled AP
Which change must be applied in the advanced WLAN settings to resolve this issue?

A. Enable Aironet IE.

B. Enable passive client.

C. Disable AAA override.

D. Disable FlexConnect local switching.

By default, which virtual MAC address does HSRP group 32 use?

A. 04:19:01:05:2e:32

B. 05:5e:5c:ac:0c:32

C. 00:00:0c:07:ac:20

D. 00:5e:0c:07:ac:20

Which two Cisco SD-WAN components exchange OMP information? (Choose two.)

A. WAN Edge

B. vBond

C. vManage

D. vAnalytics

E. vSmart