Question 501
An engineer is configuring Local WebAuth on a Cisco Wireless LAN Controller. According to RFC 5737, which virtual IP address must be used in this configuration?
A. 172.20.10.1
B. 192.168.0.1
C. 1.1.1.1
D. 192.0.2.1
Question 502
Refer to the exhibit. The OSPF neighborship fails between two routers. What is the cause of this issue?
A. The OSPF process is stopped on the neighbor router.
B. The OSPF router ID is missing on this router.
C. The OSPF router ID is missing on the neighbor router.
D. There is an MTU mismatch between the two routers.
Question 503
In Cisco DNA Center what is the integration API?
A. southbound consumer-facing RESTful API, which enables network discovery and configuration management
B. westbound interface, which allows the exchange of data to be used by ITSM, IPAM and reporting
C. an interface between the controller and the network devices, which enables network discovery and configuration management
D. northbound consumer-facing RESTful API which enables network discovery and configuration management
Question 504
An engineer must configure a new WLAN that allows a user to enter a passphrase and provides forward secrecy as a security measure
Which Layer 2 WLAN configuration is required on the Cisco WLC?
A. WPA3 Enterprise
B. WPA2 Personal
C. WPA2 Enterprise
D. WPA3 Personal
Question 505
How does an on-premises infrastructure compare to a cloud infrastructure?
A. On-premises offers faster deployment than cloud.
B. On-premises requires less power and cooling resources than cloud.
C. On-premises offers lower latency for physically adjacent systems than cloud.
D. On-premises can increase compute power faster than cloud.
Question 506
DRAG DROP -Drag and drop the characteristics from the left onto the orchestration tools that they describe on the right.
Select and Place:
Question 507
An engineer must create a script to append and modify device entries in a JSON-formatted file. The script must work as follows:
- Until interrupted from the keyboard, the script reads in the hostname of a device, its management IP address operating system type, and CLI remote access protocol.
- After being interrupted, the script displays the entered entries and adds them to the JSON-formatted file, replacing existing entries whose hostname matches.
The contents of the JSON-formatted file are as follows:
Question 508
Refer to the exhibit. An engineer configures HSRP and enters the show standby command
Which two facts about the network environment are derived from the output? (Choose two.)
A. If the local device fails to receive a hello from the active router for more than 5 seconds, it becomes the active router.
B. If a router with a higher IP address and same HSRP priority as the active router becomes available that router becomes the new active router 5 seconds later.
C. The virtual IP address of the HSRP group is 10.1.1.1.
D. The hello and hold timers are set to custom values.
E. The local device has a higher priority setting than the active router.
Question 509
Refer to the exhibit. Cisco IOS routers R1 and R2 are interconnected using interface Gi0/0
Which configuration allows R1 and R2 to form an OSPF neighborship on interface Gi0/0?
A. R2(config)#interface Gi0/0 R2(config-if)#ip ospf cost 1
B. R1(config)#router ospf 1 R1(config-if)#network 172.20.0.0 0.0.0.255 area 1
C. R1(config)#router ospf 1 R1(config-router)#no passive-interface Gi0/0
D. R2(config)#router ospf 1 R2(config-router)#passive-interface Gi0/0
Question 510
Refer to the exhibit. After configuring the BGP network an engineer verifies that the path between Server1 and Server2 is functional. Why did RouterSF choose the route from RouterDAL instead of the route from RouterCHI?
A. BGP is not running on RouterCHI
B. There is a static route in RouterSF for 10.0.0.0/24
C. The route from RouterDAL has a lower MED
D. The Router-ID for Router DAL is lower than the Router-ID for RouterCHI
