Question 51
An engineer must configure MSE to provide guests access using social media authentication. Which service does the engineer configure so that guests useFacebook credentials to authenticate?
A. Social Connect
B. Client Connect
C. Visitor Connect
D. Guest Connect
Question 52
A network engineer has been hired to perform a new MSE implementation on an existing network. The MSE must be installed in a different network than the CiscoWLC. Which configuration allows the devices to communicate over NMSP?
A. Allow UDP/16113 port on the central switch.
B. Allow TCP/16113 port on the firewall.
C. Allow UDP/16666 port on the VPN router.
D. Allow TCP/16666 port on the router.
Question 53
What is the default NMSP echo interval between Cisco MSE and a Wireless LAN Controller?
A. 10 seconds
B. 15 seconds
C. 30 seconds
D. 60 seconds
Question 54
An engineer just added a new MSE to Cisco Prime Infrastructure and wants to synchronize the MSE with the Cisco 5520 WLC, located behind a firewall in a DMZ.It is noticed that NMSP messages are failing between the two devices. Which traffic must be allowed on the firewall to ensure that the MSE and WLC are able to communicate using NMSP?
A. TCP 1613
B. UDP 16113
C. UDP 1613
D. TCP 16113
Question 55
Refer to the exhibit. An engineer needs to configure __cpLocation services in an office. The requirement is to use FastLocate and achieve higher __cpLocations refresh rates. Which __cpLocation-based technique should be implemented?
A. probe-based
B. __cpLocation patterning
C. data packet-based
D. angulation
Question 56
An engineer is managing a wireless network for a shopping center. The network includes a Cisco WLC, a Cisco MSE, and a Cisco Prime Infrastructure. What is required to use Cisco CMX Location Analytics?
A. Enable tracking parameters in Cisco MSE.
B. Enable Context Aware and CMX Browser Engage.
C. Install Cisco Prime Infrastructure with floor maps.
D. Set history parameters in Cisco MSE.
Question 57
An engineer configures a deployment to support: *Cisco CMX *licenses for at least 3000 APs *6000 wIPS licensesThe Cisco vMSE appliance must be sized for this deployment. Which Cisco vMSE Release 8 option must the engineer deploy?
A. Large vMSE
B. Low-End vMSE
C. Standard vMSE
D. High-End vMSE
Question 58
A new MSE with wIPS service has been installed and no alarm information appears to be reaching the MSE from controllers. Which protocol must be allowed to reach the MSE from the controllers?
A. SOAP/XML
B. NMSP
C. CAPWAP
D. SNMP
Question 59
Which two statements about the requirements for a Cisco Hyper__cpLocation deployment are true? (Choose two.)
A. After enabling Cisco Hyper__cpLocation on Cisco CMX, the APs and the wireless LAN controller must be restarted.
B. NTP can be configured, but that is not recommended.
C. The Cisco Hyper__cpLocation feature must be enabled on the wireless LAN controller and Cisco CMX.
D. The Cisco Hyper__cpLocation feature must be enabled only on the wireless LAN controller.
E. If the Cisco CMX server is a VM, a high-end VM is needed for Cisco Hyper__cpLocation deployments.
Question 60
An engineer is performing a Cisco Hyper__cpLocation accuracy test and executes the cmxloc start command on Cisco CMX. Which two parameters are relevant?(Choose two.)
A. X, Y real __cpLocation
B. client description
C. AP name
D. client MAC address
E. WLC IP address
