Question 41
A wireless network has been implemented to enable multicast video to be streamed reliably over the wireless link to the wireless users. After a client reports that the video is unable to stream, the administrator determines that the client is connecting at a data rate of 12 Mbps and is trying to stream to a valid multicast address on the network. Which two actions must be applied? (Choose two.)
A. Turn off IGMP snooping for all the configured WLANs on the controller.
B. Implement video-stream for the multicast video on the controller.
C. Allow multicast-direct to work correctly and multicast-direct to be enabled globally.
D. Change the WLAN QoS value to Bronze for the WLAN that multicast will be enabled.
E. Allow RTSP to stream the video due to wireless multicast not using acknowledgements.
Question 42
Which two restrictions are in place with regards to configuring mDNS? (Choose two.)
A. mDNS uses only UDP port 5436 as a destination port.
B. mDNS cannot use UDP port 5353 as the destination port.
C. mDNS is not supported on FlexConnect APs with a locally switched WLAN.
D. Controller software must be newer than 7.0.6+.
E. mDNS is not supported over IPv6.
Question 43
A network engineer needs to configure multicast in the network. The implementation will use multiple multicast groups and PIM routers. Which address provides automatic discovery of the best RP for each multicast group?
A. 224.0.0.13
B. 224.0.0.14
C. 224.0.1.39
D. 224.0.1.40
Question 44
A shopping center uses AireOS controllers with Cisco Wave 2 APs. A separate WLAN named Guest-012345678-WLAN is used for guest wireless clients.Management needs __cpLocation analytics to determine popular areas. CMX must track only associated clients. What must be selected on the CMX server settings?
A. Exclude probing clients
B. Duty Cycle Cutoff
C. Enable Locally Administered MAC Filtering
D. Enable Location MAC Filtering
Question 45
A wireless engineer needs to implement client tracking. Which method does the angle of arrival use to determine the __cpLocation of a wireless device?
A. received signal strength
B. triangulation
C. time distance of arrival
D. angle of incidence
Question 46
Which two steps are needed to complete integration of the MSE to Cisco Prime Infrastructure to track the __cpLocation of clients/rogues on maps? (Choose two.)
A. Synchronize access points with the MSE.
B. Add the MSE to Cisco Prime Infrastructure using the CLI credentials.
C. Add the MSE to Cisco Prime Infrastructure using the Cisco Prime Infrastructure communication credentials.
D. Apply a valid license for Wireless Intrusion Prevention System.
E. Apply a valid license for __cpLocation tracking.
Question 47
An IT department receives a report of a stolen laptop and has information on the MAC address of the laptop. Which two settings must be set on the wireless infrastructure to determine its __cpLocation? (Choose two.)
A. Location History for Clients must be enabled on the MSE.
B. Client __cpLocation tracking must be enabled on the MSE.
C. Location History for Visitors must be enabled on the MSE.
D. Location History for Rogue APs & Rogue Clients must be enabled on the MSE.
E. Tracking optimization must be enabled on the WLC.
Question 48
Refer to the exhibit. An engineer needs to manage non-802.11 interference. What is observed in the output on PI?
A. At least one strong interferer is impacting connectivity at this site.
B. Several light interferers are collectively impacting connectivity at this site.
C. The three individual clusters shown indicate poor AP placement.
D. RF at this site is unable to provide adequate wireless performance.
Question 49
After looking in the logs, an engineer notices that RRM keeps changing the channels for non-IEEE 802.11 interferers. After surveying the area, it has been decided that RRM should not change the channel. Which feature must be enabled to ignore non-802.11 interference?
A. Avoid Cisco AP Load
B. Avoid Non-802.11 Noise
C. Avoid Persistent Non-WiFi Interference
D. Avoid Foreign AP Interference
Question 50
Which two protocols are used to communicate between the Cisco MSE and the Cisco Prime Infrastructure network management software? (Choose two.)
A. HTTPS Most Voted
B. Telnet
C. SOAP Most Voted
D. SSH
E. NMSP
