Win IT Exam with Last Dumps 2025

Which default condition must be considered when an encrypted mobility tunnel is used between two Cisco WLCs?

A. The tunnel uses the IPses protocol for encapsulation. B. Control and data traffic encryption are enabled. C. The tunnel uses the EoIP protocol to transmit data traffic. D. TCP port 443 and UDP 21 are used.

Refer to the exhibit. After a recent internal security audit, the network administrator decided to block all P2P-capable devices from the selected SSID.
Which configuration setting must the administrator apply?

A. Set the Wi-Fi Direct Client Policy to Not-Allow. B. Select a correctly configured Layer 2 ACL. C. Set the MFP Client Protection to Required. D. Set the P2P Block Action to Drop.

What is the primary purpose of a console port on a Cisco WLC?

A. in-band management via an asynchronous transport B. in-band management via an IP transport C. out-of-band management via an asynchronous transport D. out-of-band management via an IP transport

Which port type does a lightweight AP use to connect to the wired network when it is configured in local mode?

A. EtherChannel B. access C. LAG D. trunk

Which step immediately follows receipt of the EAP success message when session resumption is disabled for an EAP-TLS connection?

A. PMKID caching B. four-way handshake C. 802.1X authentication D. EAPOL-key frame

Refer to the exhibit. All interfaces are in the same VLAN. All switches are configured with the default STP priorities. During the STP elections, which switch becomes the root bridge?

A. MDF-DC-1: 08:E0:43:42:70:13 B. MDF-DC-2: 08:0E:18:22:05:97 C. MDF-DC-4: 08:E0:19:A1:B3:19 D. MDF-DC-3: 08:0E:18:1A:3C:9D

What is a reason to implement LAG on a Cisco WLC?

A. Allow for stateful failover between WLCs. B. Increase security by encrypting management frames. C. Increase the available throughput on the link. D. Enable the connected switch ports to use different Layer 2 configurations.

A wireless access point is needed and must meet these requirements:
* “zero-touch” deployed and managed by a WLC
* process only real-time MAC functionality
* used in a split-MAC architecture

Which access point type must be used?

A. mesh B. autonomous C. lightweight D. cloud-based

Which interface is used for out-of-band management on a WLC?

A. management B. virtual C. dynamic D. service port

Refer to the exhibit. How does SW2 interact with other switches in this VTP domain?

A. It transmits and processes VTP updates from any VTP clients on the network on its trunk ports. B. It processes VTP updates from any VTP clients on the network on its access ports. C. It receives updates from all VTP servers and forwards all locally configured VLANs out all trunk ports. D. It forwards only the VTP advertisements that it receives on its trunk ports.