If both the ospf cost and bandwidth-reference commands are configured on an interface, the value set in the ospf cost command is used as the cost of the interface.
Question 72
The vlink-peer command is used to specify a peer IP address for setting up a virtual link.
Question 73
The bandwidth-reference parameter is measured in Mbit/s.
Question 74
Which of the following statements about BFD are true? (Choose three.)
Question 75
Which of the following statements about the Monitor Link group is false?
Question 76
An OSPF neighbor relationship fails to be established and the display ospf error command output is as follows.Which of the following is the probable cause?
Question 77
A network administrator needs to construct a small-scale network containing only 22 hosts and the ISP assigns only one public IP address as the egress address.Which of the following addresses can be used by the network administrator to plan the network?
Question 78
Which of the following statements about state transition are true? (Choose three.)
Question 79
On a non-broadcast network, OSPF has two operating modes: NBMA and P2MP.
Question 80
The most remarkable characteristic of OSPF is that OSPF supports the link-state algorithm.
