Refer to the exhibit. Which configuration must be applied to each of the four routers on the network to reduce LDP LIB size and advertise label bindings for the /32 loopback IP space only?
A.
B.
C.
D.
Question 132
DRAG DROP -Drag and drop the OSPF and IS-IS Cisco MPLS TE extensions from the left to their functional descriptions on the right.Select and Place:
Question 133
DRAG DROP -Drag and drop the methods of Cisco MPLS TE tunnel traffic assignment from the left onto their characteristics on the right.Select and Place:
Question 134
Refer to the exhibit. A network engineer is configuring MPLS LDP synchronization on router R1. Which additional configuration must an engineer apply to R1 so that it will synchronize to OSPF process 1?
A.
B.
C.
D.
Question 135
Refer to the exhibit. An engineer must configure router R2 as the new P router in the network. Which configuration must be applied to R2 to enable LDP-IGP Sync on its L2 IS-IS adjacencies?
A.
B.
C.
D.
Question 136
Refer to the exhibit. What type of configuration is it?
A. It is configuration that requires OSPF to also be running to have optimized Cisco MPLS TE tunnels
B. It is configuration that requires a dynamic Cisco MPLS TE path to be configured for the tunnel to run
C. It is configuration for the head-end router of a Cisco MPLS TE tunnel with segment routing
D. It is configuration that requires an explicit Cisco MPLS TE path to be configured for the tunnel to run
Question 137
Refer to the exhibit. An engineer is configuring two routers to support MPLS LDP sessions between them. The R1 configuration is complete, and work has started on R2 as shown. Which additional configuration must the engineer apply to R2 to complete the task?
A.
B.
C.
D.
Question 138
What are two characteristics of MPLS TE tunnels? (Choose two.)
A. They are unidirectional
B. The headend and tailend routers of the tunnel must have a BGP relationship
C. They are run over Ethernet cores only
D. They use RSVP to provide bandwidth for the tunnel
E. They require EIGRP to be running in the core
Question 139
What is the characteristic of the TI-LFA?
A. It guarantees a loop-free path for all areas configured in OSPF
B. It guarantees a loop-free path for all interfaces in the OSPF super backbone
C. It applies only on the instance and makes all the interfaces inherit the configuration
D. It applies on the area and instance and makes all the interfaces inherit the configuration
Question 140
Which two actions describe LSP delegation to PCE servers? (Choose two.)
A. removing TE re-optimization timer timeouts
B. changing the precedence of any of the PCE servers
C. entering the mpls traffic-eng reoptimize command
D. adding a new PCE server with lower precedence than the primary PCE
E. adding a new PCE server with higher precedence than the primary PCE
