Refer to the exhibit. With which router does IOSXRV-1 have LDP session protection capability enabled but session hold up is not active?
A. 192.168.0.4
B. 192.168.0.5
C. 192.168.0.1
D. 192.168.0.3
Question 122
Refer to the exhibit. A network operator working for service provider with an employee id: 1234:56:789 applied this configuration to a router.Which additional step should the engineer use to enable LDP?
A. Enable MPLS LDP on the interface.
B. Disable Cisco Express Forwarding globally.
C. Delete the static router ID.
D. Configure the both keyword to enable LDP globally.
Question 123
Which utility can you use to locate MPLS faults?
A. MPLS LSP ping
B. QoS
C. MPLS traceroute
D. EEM
Question 124
When configuring traffic engineering tunnels in Cisco MPLS core network, you see the traffic is not tacking the expected path in the core.Which command do you use to quickly check path of a TE tunnel?
A. traceroute
B. show mpls traffic-engineering tunnels
C. Ping
D. traceroute mpls ipv4
Question 125
DRAG DROP -Drag and drop the LDP features from the left onto the correct usages on the right.Select and Place:
Question 126
Refer to the exhibit. When implementing an LDP protocol, an engineer experienced an issue between two directly connected routers and noticed that no LDP neighbor exists for 1.1.1.1.Which factor should be the reason for this situation?
A. LDP needs to be enabled on the R2 loopback interface.
B. LDP needs to be enabled on the R2 physical interface.
C. R2 does not see any hellos from R1.
D. R2 sees the wrong type of hellos from R1.
Question 127
Refer to the exhibit. Which statement about this configuration is true?
A. It requires a dynamic Cisco MPLS TE path to be configured for the tunnel to run.
B. It requires OSPF to also be running to have optimized Cisco MPLS TE tunnels.
C. It is the configuration for the head-end router of a Cisco MPLS TE tunnel with segment routing.
D. It requires an explicit Cisco MPLS TE path to be configured for the tunnel to run.
Question 128
Which statement about segment routing prefix segments is true?
A. It is the longest path to a node.
B. It is linked to an adjacency SID that is globally unique within the router.
C. It is linked to a prefix SID that is globally unique within segment routing domain.
D. It requires using EIGRP to operate.
Question 129
Refer to the exhibit. After implementing a new design for the network, a technician reviews the pictures CLI output as part of the MOP.Which two elements describe what the technician can ascertain from the ImpNull output? (Choose two.)
A. Ultimate Hop Popping is in use for the prefix displayed.
B. Penultimate Hop Popping is in use for the prefix displayed.
C. Label 0 is used for the prefix displayed, but will not be part of the MPLS label stack for packets destined for 192.168.10.10.
D. Label 3 is in use for the prefix displayed and will be part of the MPLS label stack for packets destined for 192.168.10.10.
E. Label 0 is used for the prefix displayed and will be part of the MPLS label stack for packets destined for 192.168.10.10.
Question 130
A router RP is configured to perform MPLS LDP graceful restart.Which three steps are included when the RP sends an LDP initialization message to a neighbor to establish an LDP session? (Choose three.)
