Question 211
How are the different versions of IGMP compatible?
A. IGMPv2 is compatible only with IGMPv2.
B. IGMPv3 is compatible only with IGMPv3.
C. IGMPv2 is compatible only with IGMPv1.
D. IGMPv3 is compatible only with IGMPv1
Question 212
Which measurement is used from a post wireless survey to depict the cell edge of the access points?
A. SNR
B. Noise
C. RSSI Most Voted
D. CCI
Question 213
If a client's radio device receives a signal strength of -67 dBm and the noise floor is -85 dBm, what is the SNR value?
A. 15 dB
B. 16 dB
C. 18 dB
D. 20 dB
Question 214
Which AP mode allows an engineer to scan configured channels for rogue access points?
A. monitor
B. bridge
C. local
D. sniffer
Question 215
Refer to the exhibit. While troubleshooting a routing issue, an engineer issues a ping from S1 to S2. Which two actions result from the initial value of the TTL?(Choose two.)
A. The packet reaches R2, and the TTL expires. Most Voted
B. R1 replies with a TTL exceeded message.
C. The packet reaches R3, and the TTL expires. Most Voted
D. R2 replies with a TTL exceeded message. Most Voted
E. R3 replies with a TTL exceeded message. Most Voted
F. The packet reaches R1, and the TTL expires.
Question 216
What is the wireless Received Signal Strength Indicator?
A. the value given to the strength of the wireless signal received compared to the noise level
B. the value of how strong the wireless signal is leaving the antenna using transmit power, cable loss, and antenna gain
C. the value of how much wireless signal is lost over a defined amount of distance
D. the value of how strong a wireless signal is received, measured in dBm
Question 217
Which two operational modes enable an AP to scan one or more wireless channels for rogue access points and at the same time provide wireless services to clients? (Choose two.)
A. monitor
B. rogue detector
C. FlexConnect Most Voted
D. sniffer
E. local Most Voted
Question 218
Refer to the exhibit. An engineer attempts to configure a trunk between switch SW1 and switch SW2 using DTP, but the trunk does not form. Which command should the engineer apply to switch SW2 to resolve this issue?
A. switchport nonegotiate
B. no switchport
C. switchport mode dynamic desirable
D. switchport mode access
Question 219
An engineer is troubleshooting the AP join process using DNS. Which FQDN must be resolvable on the network for the access points to successfully register to the WLC?
A. wlchostname.domain.com
B. cisco-capwap-controller.domain.com
C. ap-manager.domain.com
D. primary-wlc.domain.com
Question 220
Which new enhancement was implemented in Wi-Fi 6?
A. Uplink and Downlink Orthogonal Frequency Division Multiple Access
B. Channel bonding
C. Wi-Fi Protected Access 3
D. 4096 Quadrature Amplitude Modulation Mode
