Question 131
When configuring WPA2 Enterprise on a WLAN, which additional security component configuration is required?
A. PKI server
B. NTP server
C. RADIUS server
D. TACACS server
Question 132
A customer has several small branches and wants to deploy a Wi-Fi solution with local management using CAPWAP.Which deployment model meets this requirement?
A. local mode
B. autonomous
C. SD-Access wireless
D. Mobility Express
Question 133
Refer to the exhibit.The WLC administrator sees that the controller to which a roaming client associates has Mobility Role Anchor configured under Clients > Detail.Which type of roaming is supported?
A. indirect
B. Layer 3 intercontroller Most Voted
C. intracontroller
D. Layer 2 intercontroller
Question 134
DRAG DROP -Drag and drop the characteristics from the left onto the correct routing protocol types on the right.Select and Place:
Question 135
Which feature is supported by EIGRP but is not supported by OSPF?
A. route filtering
B. unequal-cost load balancing
C. route summarization
D. equal-cost load balancing
Question 136
What is the correct EBGP path attribute list, ordered from most preferred to least preferred, that the BGP best-path algorithm uses?
A. local preference, weight, AS path, MED
B. weight, local preference, AS path, MED
C. weight, AS path, local preference, MED
D. local preference, weight, MED, AS path
Question 137
A local router shows an EBGP neighbor in the Active state.Which statement is true about the local router?
A. The local router is attempting to open a TCP session with the neighboring router.
B. The local router is receiving prefixes from the neighboring router and adding them in RIB-IN.
C. The local router has active prefixes in the forwarding table from the neighboring router.
D. The local router has BGP passive mode configured for the neighboring router.
Question 138
Refer to the exhibit.SwitchC connects HR and Sales to the Core switch. However, business needs require that no traffic from the Finance VLAN traverse this switch.Which command meets this requirement?
A. SwitchC(config)#vtp pruning vlan 110
B. SwitchC(config)#vtp pruning
C. SwitchC(config)#interface port-channel 1 SwitchC(config-if)#switchport trunk allowed vlan add 210,310
D. SwitchC(config)#interface port-channel 1 SwitchC(config-if)#switchport trunk allowed vlan remove 110
Question 139
Refer to the exhibit.An engineer must ensure that all traffic leaving AS 200 will choose Link 2 as the exit point.Assuming that all BGP neighbor relationships have been formed and that the attributes have not been changed on any of the routers, which configuration accomplishes this task?
A. R4(config-router)bgp default local-preference 200
B. R3(config-router)bgp default local-preference 200
C. R4(config-router)neighbor 10.2.2.2 weight 200
D. R3(config-router)neighbor 10.1.1.1 weight 200
Question 140
Which feature of EIGRP is not supported in OSPF?
A. load balancing of unequal-cost paths
B. load balance over four equal-cost paths
C. uses interface bandwidth to determine best path
D. per-packet load balancing over multiple paths
