Question 11
An organization is supporting remote workers in different __cpLocations. In order to provide wireless network connectivity and services, OfficeExtend has been implemented. The wireless connectivity is working, but users report losing connectivity to their local network printers. Which solution must be used to address this issue?
A. OEAP gateway override
B. OEAP split tunnel
C. WLAN static IP tunneling
D. FlexConnect local switching
Question 12
What is configured to use more than one port on the OEAP to extend the wired network?
A. remote LAN ACL
B. AAA override
C. client load balancing
D. remote LAN
Question 13
An engineer must implement Cisco Identity-Based Networking Services at a remote site using ISE to dynamically assign groups of users to specific IP subnets. If the subnet assigned to a client is available at the remote site, then traffic must be offloaded locally, and subnets are unavailable at the remote site must be tunneled back to the WLC. Which feature meets these requirements?
A. learn client IP address
B. FlexConnect local authentication
C. VLAN-based central switching
D. central DHCP processing
Question 14
An engineer must configure Cisco OEAPs for three executives. As soon as the NAT address is configured on the management interface, it is noticed that the WLC is not responding for APs that are trying to associate to the internal IP management address. Which command should be used to reconcile this?
A. config flexconnect office-extend nat-ip-only disable
B. config network ap-discovery nap-ip-only enable
C. config flexconnect office-extend nat-ip-only enable
D. config network ap-discovery nat-ip-only disable
Question 15
An engineer is responsible for a wireless network for an enterprise. The enterprise has distributed offices around the globe, and all APs are configured inFlexConnect mode. The network must be configured to support 802.11r and CCKM. What needs to be implemented to accomplish this goal?
A. Enable VLAN-based central switching.
B. Enable FlexConnect local authentication.
C. Enable FlexConnect local switching.
D. Create FlexConnect groups.
Question 16
A corporation has employees working from their homes. A wireless engineer must connect 1810 OEAP at remote teleworker __cpLocations. All configuration has been completed on the controller side, but the network readiness is pending. Which two configurations must be performed on the firewall to allow the AP to join the controller? (Choose two.)
A. Block UDP ports 1812 and 1813 on the firewall.
B. Enable NAT Address on the 5520 with an Internet-routable IP address.
C. Configure a static IP on the OEAP 1810.
D. Allow UDP ports 5246 and UDP port 5247 on the firewall.
E. Allow UDP ports 12222 and 12223 on the firewall.
Question 17
An enterprise has two WLANs configured on WLC. It is reported that when converting APs to FlexConnect mode, WLAN A works but WLAN B does not. When converting APs to local mode, WLAN B works, but WLAN A does not. Which action is needed to complete this configuration?
A. Create a Cisco FlexConnect group with WLAN-VLAN mapping.
B. Disable local switching on the WLANs.
C. Map the AP group to the WLAN interface.
D. Join the APs to a Cisco FlexConnect group.
Question 18
An engineer wants the wireless voice traffic class of service to be used to determine the queue order for packets received, and then have the differentiated services code point set to match when it is resent to another port on the switch. Which configuration is required in the network?
A. Platinum QoS configured on the WLAN
B. WMM set to required on the WLAN
C. msl qos trust dscp configured on the controller switch port
D. msl qos trust cos configured on the controller switch port
Question 19
When using a Cisco Catalyst 9800 Series Wireless Controller, which statement about AutoQoS is true?
A. It has a set of predefined profiles that you cannot modify further
B. It matches traffic and assigns each matched packet to QoS groups
C. It automates deployment of wired QoS and makes wireless QoS implementation easier
D. It allows the output policy map to put specific QoS queues into specific subgroups
Question 20
A network engineer is deploying 8865 IP phones with wireless clients connected to them. In order to apply the appropriate QoS, the IP voice traffic needs to be distinguished from client data traffic. Which switch configuration feature must be enabled?
A. Voice VLAN
B. QBSS
C. WME
D. QoS routing
