Win IT Exam with Last Dumps 2025

Refer to the exhibits. To provide reachability to network 10.1.1.0/24 from R5, the network administrator redistributes EIGRP into OSPF on R3 but notices that R4 is now taking a suboptimal path through R5 to reach 10.1.1.0/24 network. Which action fixes the issue while keeping the reachability from R5 to 10.1.1.0/24 network?

A. Change the administrative distance of the external EIGRP to 90.

B. Apply the outbound distribution list on R5 toward R4 in OSPF.

C. Change the administrative distance of OSPF to 200 on R5.

D. Redistribute OSPF into EIGRP on R4.

Refer to the exhibits. All the serial links between R1, R2, and R3 have the same bandwidth. Users on the 192.168.1.0/24 network report slow response times while they access resources on network 192.168.3.0/24. When a traceroute is run on the path, it shows that the packet is getting forwarded via R2 to R3 although the link between R1 and R3 is still up. What must the network administrator do to fix the slowness?

A. Add a static route on R1 using the next hop of R3.

B. Remove the static route on R1.

C. Change the Administrative Distance of EIGRP to 5.

D. Redistribute the R1 static route to EIGRP.

Refer to the exhibit. The R1 and R2 configurations are:

A.

B.

C.

D.

E.

Refer to the exhibit. The network administrator must mutually redistribute routes at the Chicago router to the LA and NewYork routers. The configuration of the Chicago router is this, After the configuration, the LA router receives all the NewYork routes, but the NewYork router does not receive any LA routes. Which set of configurations fixes the problem on the Chicago router?

A.

B.

C.

D.

DRAG DROP - Drag and drop the actions from the left into the correct order on the right to configure a policy to avoid following packet forwarding based on the normal routing path. Select and Place:

Refer to the exhibit. An engineer wanted to set a tag of 30 to route 10.1.80.65/32 but it failed. How is the issue fixed?

A. Modify route-map ospf-to-eigrp permit10 and match prefix-list ccnp2.

B. Modify prefix-list ccnp3 to add 10.1.64.0/20 ge 32.

C. Modify prefix-list ccnp3 to add 10.1.64.0/20 le 24.

D. Modify route-map ospf-to-eigrp permit 30 and match prefix-list ccnp2.

Refer to the exhibits. A company with autonomous system number AS65401 has obtained IP address block 209.165.200.224/27 from ARIN. The company needed more IP addresses and was assigned block 209.165.202.128/27 from ISP2. An engineer in ISP1 reports that they are receiving ISP2 routes from AS65401. Which configuration on R1 resolves the issue?

A.

B.

C.

D.

After some changes in the routing policy, it is noticed that the router in AS 45123 is being used as a transit AS router for several service providers. Which configuration ensures that the branch router in AS 45123 advertises only the local networks to all SP neighbors?

A.

B.

C.

D.

A network administrator is troubleshooting a high utilization issue on the route processor of a router that was reported by NMS. The administrator logged into the router to check the control plane policing and observed that the BGP process is dropping a high number of routing packets and causing thousands of routes to recalculate frequently. Which solution resolves this issue?

A. Shape the pir for BGP, conform-action set-prec-transmit, and exceed action set-frde-transmit.

B. Police the pir for BGP, conform-action set-prec-transmit, and exceed action set-clp-transmit.

C. Shape the cir for BGP, conform-action transmit, and exceed action transmit.

D. Police the cir for BGP, conform-action transmit, and exceed action transmit.

Which mechanism must be chosen to optimize the reconvergence time for OSPF at company location 408817202 that is less CPU-intensive than reducing the hello and dead timers?

A. sso

B. BFD

C. Dead Peer Detection keepalives

D. OSPF demand circuit