Refer to the exhibit. R1 and R2 are configured for EIGRP peering using authentication and the neighbors failed to come up. Which action resolves the issue?
A. Configure a matching lowest key-id on both routers.
B. Configure a matching authentication type on both routers.
C. Configure a matching key-id number on both routers.
D. Configure a matching key-chain name on both routers.
Question 232
Refer to the exhibit. Mutual redistribution is enabled between RIP and EIGRP on R2 and R5. Which configuration resolves the routing loop for the 192.168.1.0/24 network?
Refer to the exhibit. R4 is experiencing packet drop when trying to reach 172.16.2.7 behind R2. Which action resolves the issue?
A. Insert a /24 floating static route on R2 toward R3 with metric 254.
B. Disable auto summarization on R2.
C. Enable auto summarization on all three routers R1, R2, and R3.
D. Insert a /16 floating static route on R2 toward R3 with metric 254.
Question 234
Refer to the exhibit. An engineer must advertise routes into IPv6 MP-BGP and failed. Which configuration resolves the issue on R1?
A. router bgp 64900 no bgp default ipv4-unicast address-family ipv6 unicast redistribute ospf network 2001:DB9::/64
B. router bgp 64900 no bgp default ipv4-unicast address-family ipv6 multicast neighbor 2001:DB8:7000::2 translate-update ipv6 multicast
C. router bgp 65000 no bgp default ipv4-unicast address-family ipv6 unicast network 2001:DB8::/64
D. router bgp 65000 no bgp default ipv4-unicast address-family ipv6 multicast network 2001:DB8::/64
Question 235
Refer to the exhibit. A network engineer applied a filter for ISA traffic on OSPFv3 inter area routes on the area 5 ABR to protect advertising the internal routes of area 5 to the business partner network. All other areas should receive the area 5 internal routes. After the respective route filtering configuration is applied on theABR, area 5 routes are not visible on any of the areas. How must the filter list be applied on the ABR to resolve this issue?
A. in the "in" direction for area 5 on router R1
B. in the "in" direction for area 20 on router R2
C. in the "out" direction for area 20 on router R2
D. in the "out" direction for area 5 on router R1
Question 236
Refer to the exhibit. The R2 loopback interface is advertised with RIP and EIGRP using default values. Which configuration changes make R1 reach the R2 loopback using RIP?
A. R1(config)#router rip R1(config-router)#distance 90
B. R1(config)#router eigrp 1 R1(config-router)#distance eigrp 130 120
C. R1(config)#router rip R1(config-router)#distance 100
D. R1(config)#router eigrp 1 R1(config-router)#distance eigrp 120 120
Question 237
Refer to the exhibit. R6 should reach R1 via R5>R2>R1. Which action resolves the issue?
A. Decrease the cost to 2 between R6-R5-R2.
B. Increase the cost to 61 between R2-R3-R1.
C. Increase the cost to 61 between R2 and R3.
D. Decrease the cost to 41 between R2 and R1.
Question 238
An engineer failed to run diagnostic commands on devices using Cisco DNA Center. Which action in Cisco DNA Center resolves the issue?
A. Enable Secure Shell.
B. Enable APIs.
C. Enable CDP.
D. Enable Command Runner.
Question 239
Refer to the exhibit. The static route is not present in the routing table of an adjacent OSPF neighbor router. Which action resolves the issue?
A. Configure a permit 20 statement to the route map to redistribute the static route.
B. Configure the next-hop interface at the end of the static route for it to get redistributed.
C. Configure the next hop of 10.20.20.1 in the prefix list DMZ-STATIC.
D. Configure the subnets keyword in the redistribution command.
Question 240
Refer to the exhibit. Packets arriving from source 209.165.200.215 must be sent with the precedence bit set to 1, and packets arriving from source 209.165.200.216 must be sent with the precedence bit set to 5. Which action resolves the issue?
A. set ip precedence critical in route-map Texas permit 20
B. set ip precedence critical in route-map Texas permit 10
C. set ip precedence priority in route-map Texas permit 20
D. set ip precedence immediate in route-map Texas permit 10