Win IT Exam with Last Dumps 2024


Cisco 300-410 Exam

Page 19/30
Viewing Questions 181 190 out of 298 Questions
63.33%

Question 181
Refer to the exhibit. The remote server is failing to receive the NetFlow data.
Which action resolves the issue?
Image 300-410_181Q.png related to the Cisco 300-410 Exam
A. Modify the flow transport command transport udp 2055 to move under flow monitor profile.
B. Modify the interface command to ip flow monitor FLOW-MONITOR-1 input.
C. Modify the udp port under flow exporter profile to ip transport udp 4739.
D. Modify the flow record command record v4_r1 to move under flow exporter profile.

Question 182
Refer to the exhibit. A network administrator configured NTP on a Cisco router to get synchronized time for system and logs from a unified time source. The configuration did not work as desired.
Which service must be enabled to resolve the issue?
Image 300-410_182Q.png related to the Cisco 300-410 Exam
A. Enter the service timestamps log datetime clock-period global command.
B. Enter the service timestamps log datetime synchronize global command.
C. Enter the service timestamps log datetime console global command.
D. Enter the service timestamps log datetime localtime global command.

Question 183
Refer to the exhibits. An engineer filtered messages based on severity to minimize log messages. After applying the filter, the engineer noticed that it filtered required messages as well.
Which action must the engineer take to resolve the issue?
Image 300-410_183Q.png related to the Cisco 300-410 Exam
A. Configure syslog level 2.
B. Configure syslog level 3.
C. Configure syslog level 4.
D. Configure syslog level 5.

Question 184
An engineer is troubleshooting on the console session of a router and turns on multiple debug commands. The console screen is filled with scrolling debug messages that none of the commands can be verified if entered correctly or display any output.
Which action allows the engineer to see entered console commands while still continuing the analysis of the debug messages?
A. Configure the term no mon command globally.
B. Configure the logging synchronous level all command.
C. Configure the logging synchronous command.
D. Configure the no logging console debugging command globally.

Question 185
Refer to the exhibit. The DHCP client is unable to receive an IP address from the DHCP server. RouterB is configured as follows:
Which command is required on the fastethernet 0/0 interface of RouterB to resolve this issue?
Image 300-410_185Q.png related to the Cisco 300-410 Exam
A. RouterB(config-if)#ip helper-address 172.16.1.1
B. RouterB(config-if)#ip helper-address 255.255.255.255
C. RouterB(config-if)#ip helper-address 172.16.1.2
D. RouterB(config-if)#ip helper-address 172.31.1.1


Question 186
Refer to the exhibit. A network administrator added one router in the Cisco DNA Center and checked its discovery and health from the Network Health Dashboard.
The network administrator observed that the router is still showing up as unmonitored.
What must be configured on the router to mount it in the Cisco DNA Center?
Image 300-410_186Q.jpg related to the Cisco 300-410 Exam
A. Configure router with SNMPv2c or SNMPv3 traps
B. Configure router with the telemetry data
C. Configure router with routing to reach Cisco DNA Center
D. Configure router with NetFlow data

Question 187
Refer to the exhibit. NTP is configured across the network infrastructure and Cisco DNA Center. An NTP issue was reported on the Cisco DNA Center at 17:15.
Which action resolves the issue?
Image 300-410_187Q.png related to the Cisco 300-410 Exam
A. Reset the NTP server to resolve any synchronization issues for all devices
B. Check and resolve reachability between Cisco DNA Center and the NTP server
C. Check and resolve reachability between the WLC and the NTP server
D. Check and configure NTP on the WLC and synchronize with Cisco DNA Center

Question 188
Refer to the exhibit. PC-2 failed to establish a Telnet connection to the terminal server.
Which configuration resolves the issue?
Image 300-410_188Q.png related to the Cisco 300-410 Exam
A. Gateway-Router(config)#ipv6 access-list Default_Access Gateway-Router(config-ipv6-acl)#sequence 25 permit tcp host 2018:DB1:A:B::2 host 2018:DB1:A:C::1 eq telnet
B. Gateway-Router(config)#ipv6 access-list Default_Access Gateway-Router(config-ipv6-acl)#no sequence 20 Gateway-Router(config-ipv6-acl)#sequence 5 permit tcp host 2018:DB1:A:B::2 host 2018:DB1:A:C::1 eq telnet
C. Gateway-Router(config)#ipv6 access-list Default_Access Gateway-Router(config-ipv6-acl)#permit tcp host 2018:DB1:A:B::2 host 2018:DB1:A:C::1 eq telnet
D. Gateway-Router(config)#ipv6 access-list Default_Access Gateway-Router(config-ipv6-acl)#sequence 15 permit tcp host 2018:DB1:A:B::2 host 2018:DB1:A:C::1 eq telnet

Question 189
Refer to the exhibit. A network administrator enables DHCP snooping on the Cisco Catalyst 3750-X switch and configures the uplink port (Port-channel2) as a trusted port. Clients are not receiving an IP address, but when DHCP snooping is disabled, clients start receiving IP addresses.
Which global command resolves the issue?
Image 300-410_189Q.png related to the Cisco 300-410 Exam
A. ip dhcp relay information trust portchannel2
B. ip dhcp snooping
C. ip dhcp snooping trust
D. no ip dhcp snooping information option

Question 190
A customer reports to the support desk that they cannot print from their PC to the local printer id:123456789.
Which tool must be used to diagnose the issue using Cisco DNA Center Assurance?
A. device trace
B. ACL trace
C. path trace
D. application trace



Premium Version