Question 481
Refer to the exhibit. Router R4 is dynamically learning the path to the server. If R4 is connected to R1 via OSPF Area 20, to R2 via R2 BGP, and to R3 via EIGRP 777, which path is installed in the routing table of R4?
A. the path through R1, because the OSPF administrative distance is 110
B. the path through R2. because the IBGP administrative distance is 200
C. the path through R2 because the EBGP administrative distance is 20
D. the path through R3. because the EIGRP administrative distance is lower than OSPF and BGP
Question 482
Which HTTP status code is returned after a successful REST API request?
A. 200
B. 301
C. 404
D. 500
Question 483
Refer to the exhibit. R5 is the current DR on the network, and R4 is the BDR. Their interfaces are flapping, so a network engineer wants the OSPF network to elect a different DR and BDR. Which set of configurations must the engineer implement?
A.
B.
C.
D.
Question 484
What are network endpoints?
A. act as routers to connect a user to the service prowler network
B. a threat to the network if they are compromised
C. support inter-VLAN connectivity
D. enforce policies for campus-wide traffic going to the internet
Question 485
Refer to the exhibit. Which two prefixes are included in this routing table entry? (Choose two.)
A. 192.168.1.17
B. 192.168.1.61
C. 192.168.1.64
D. 192.168.1.127
E. 192.168.1.254
Question 486
Which two components are needed to create an Ansible script that configures a VLAN on a switch? (Choose two.)
A. cookbook
B. task
C. playbook
D. model
E. recipe
Question 487
Which two events occur automatically when a device Is added to Cisco DNA Center? (Choose two. )
A. The device Is assigned to the Global site.
B. The device Is placed into the Unmanaged state.
C. The device Is placed into the Provisioned state.
D. The device Is placed into the Managed state.
E. The device is assigned to the Local site.
Question 488
Which virtual MAC address is used by VRRP group 1?
A. 0050.0c05.ad81
B. 0007.c061.bc01
C. 0000.5E00.0101
D. 0500.3976.6401
Question 489
Refer to the exhibit. Which two commands, when configured on router R1, fulfill these requirements? (Choose two.) - Packets towards the entire network 2001:db8:2::/64 must be forwarded through router R2. - Packets toward host 2001:db8:23::14 preferably must be forwarded through R3.
A. Ipv6 route 2001:db8:23::/128 fd00:12::2
B. Ipv6 route 2001:db8:23::14/128 fd00:13::3
C. Ipv6 route 2001:db8:23::14/64 fd00:12::2
D. Ipv6 route 2001:db8:23::/64 fd00:12::2
E. Ipv6 route 2001:db8:23::14/64 fd00:12::2 200
Question 490
In software-defined architecture, which place handles switching for traffic through a Cisco router?
A. Control
B. Management
C. Data
D. application
