Question 71
Which two statements describe the connection between control plane and forwarding plane? (Choose two.)
A. No rate limiter is configured by default
B. A rate limiter is configured by default
C. Exception traffic is preferred over the control traffic during congestion
D. Control traffic is preferred over the exception traffic during congestion
Question 72
Referring to the exhibit, what will be the result?
A. The device will boot in a multi-user mode at the configuration prompt
B. The device will boot in a Single-user mode at the operational prompt
C. The device will boot in a multi-user mode at the shell prompt
D. The device will boot in a Single-user mode at the shell prompt
Question 73
When multiple users are editing the configuration on a Junos device, what is the default behavior when a user issues a commit command?
A. The user's configuration changes are committed, other users configuration changes are still pending
B. The user's configuration changes are committed, other users will be exited from the configuration mode
C. All valid configuration changes made by all users will take effect
D. The user will receive an error message disallowing a commit of the configuration
Question 74
You must configure the 2bfc:0000:0000:beef:0217:cbff:0000:5c85 IPv6 address on your device. In this scenario, which three addresses are correct? (Choose three.)
A. 2bfc::beef:217:cbff:0:5c85
B. 2bfc:0:0:beef:0217:cbff:0:5c85
C. 2BFC::BEEF:0217CBFF:0:5C85
D. 2bfc:0:beef:0217:cbff:0:5c85
E. 2BFC::BEEF:217:CBFF::5C85
Question 75
Which process is responsible for controlling all interfaces on a Junos device?
A. rpd
B. chassisd
C. dcd
D. mgd
Question 76
You have configuration groups applied on your router.
Which command would you use to see all components of the interface hierarchy?
A. show configuration interfaces | display inheritance
B. show configuration interfaces | display changed
C. show configuration interfaces | display set
D. show configuration interfaces | display detail
Question 77
You must configure the 2bfc:0000:0000:beef:0217:cbff:0000:5c85 IPv6 address on your device.
In this scenario, which three addresses are correct? (Choose three.)
A. 2BFC::BEEF:217:CBFF::5C85
B. 2BFC::BEEF:217:CBFF:0:5C85
C. 2bfc:0:beef:0217:cbff:0:5c85
D. 2bfc:0:0:beef:0217:cbff:0:5c85
E. 2BFC::BEEF:0217CBFF:0:5C85
Question 78
You successfully established a BGP session with peer, but do not see any routes learned from the peer, What would cause this problem?
A. A routing policy is blocking BGP from learning the routes
B. Unicast reverse-path-forwarding is blocking BGP from learning the routes
C. A security policy is blocking BGP from learning the routes
D. The firewall filter is blocking the BGP from learning the routes
Question 79
Which two conditions must exist in a Junos device for traffic to transit the device to a specific destination? (Choose two.)
A. A forwarding table entry for that destination must exist
B. A routing policy must be in place on the device
C. A firewall filter must exist to allow traffic to reach that destination
D. A routing table entry for that destination must exit
Question 80
You are asked to limit traffic on interface xe-0/0/3 to 1G using the policer shown in the exhibit.
Which configuration would accomplish this task?
A.
B.
C.
D.
