Question 191
To establish multiple PPP point-to-point connections in the Ethernet network, a PPPoE server establishes connections with multiple PPPoE clients on oneEthernet port.How does PPPoE differentiate between each connection?
A. MAC address.
B. IP address and MAC address
C. MAC address and ppp-id
D. MAC address and session-id
Question 192
When configuring a router as a PPPoE client, which configuration is not necessary?
A. Configuration of the dialer-rule
B. Configuration of the dialer interface
C. Configuration of an IP address on the dialer interface
D. Configuration of a password on the dialer interface
Question 193
In the PPPoE discovery stage, the PPPoE server assigns a session-id to the PPPoE client in which packet?
A. PADI
B. PADO
C. PADR
D. PADS
Question 194
Which command can be used to check the PPPoE client session status?
A. display ip interface brief
B. display current-configuration
C. display pppoe-client session packet
D. display pppoe-client session summary
Question 195
[Huawei]rip 1[Huawei-rip-1]version 2Refer to the command output. An administrator wishes to configure RIP. Which other command needs to configured for RIP routes to be advertised?
A. import-route GigabitEthernet 0/0/1
B. network 192.168.1.0 0.0.0.255
C. network GigabitEthernet 0/0/1
D. network 192.168.1.0
Question 196
A RIP router receives the routing update information from its neighbor.Which of the following statements regarding routing update are correct? (Choose three)
A. The received route that is not in the routing table will be added only when its hop count value is less than 16.
B. The received route that already exists in the routing table will be updated only when the next hop is the router's neighbor and the cost value is smaller.
C. The received route that already exists in the routing table will be updated only when the next hop is not the router's neighbor and the cost value is smaller.
D. The received route that already exists in the routing table will be updated only when the next hop is the router's neighbor and the cost value has been changed.
Question 197
Which of the following commands is used to display the current running state and configuration of RIP?
A. display protocol rip
B. show rip
C. display rip
D. display this rip
Question 198
A user can view the information for the RIP protocol on a router. What does "Age time" in the returned result of the command mean?
A. The interval of updating an RIP packet
B. The aging time of an RIP route
C. The suppression time of an RIP route
D. The time spent on switching between RIP routes
Question 199
After a command for displaying RIP route information is entered on a router, peer 192.168.1.2 on Serial1/0/0 is displayed in the returned result.What does 192.168.1.2 stand for?
A. Address of a RIP neighbor
B. Address of the port with the RIP protocol enabled
C. Next hop address of the RIP route
D. Transmission address of the RIP protocol
Question 200
Refer to the debug output. Following configuration of R2, the administrator discovers that the behavior is not as expected and performs debugging. Based on the output from the debug, what is the source of the problem?
A. R2 has configured an ACL to block the route to network 1.0.0.0
B. R2 has enabled split horizon.
C. R1 is using authentication, however R2 is not.
D. R2 is operating using RIPv2, while R1 is using RIPv1.
