Which diagnostic command can you use to show the member utilization statistics measured by performance SLAs for the last 10 minutes?
Question 2
Which two protocols in the IPsec suite are most used for authentication and encryption? (Choose two.)
Question 3
Which two settings can you configure to speed up routing convergence in BGP? (Choose two.)
Question 4
Refer to the exhibits. Exhibit A and B. Exhibit A shows the configuration for an SD-WAN rule and exhibit B shows the respective rule status, the routing table, and the member status. The administrator wants to understand the expected behavior for traffic matching the SD-WAN rule. Based on the exhibits, what can the administrator expect for traffic matching the SD-WAN rule?
Question 5
Refer to the exhibit. Two hub-and-spoke groups are connected through a site-to-site IPsec VPN between Hub 1 and Hub 2. The administrator configured ADVPN on both hub-and-spoke groups. Which two outcomes are expected if a user in Toronto sends traffic to London? (Choose two.)
Question 6
Which two performance SLA protocols enable you to verify that the server response contains a specific value? (Choose two.)
Question 7
Refer to the exhibit. Which two conclusions for traffic that matches the traffic shaper are true? (Choose two.)
Question 8
Refer to the exhibit. Which configuration change is required if the responder FortiGate uses a dynamic routing protocol to exchange routes over IPsec?
Question 9
Which CLI command do you use to perform real-time troubleshooting for ADVPN negotiation?
Question 10
Refer to the exhibits. Exhibit A shows the system interface with the static routes and exhibit B shows the firewall policies on the managed FortiGate. Based on the FortiGate configuration shown in the exhibits, what issue might you encounter when creating an SD-WAN zone for port1 and port2?
