Win IT Exam with Last Dumps 2024

A network engineer is deploying VRF on ASBR router R1. The interface must have connectivity over an MPLS VPN Inter-AS Option AB network. Which configuration must the engineer apply on the router to accomplish this task?

A. B. C. D.

Refer to the exhibit. ASN 64501 currently reaches the networks under the 10.0.0.0/8 prefix via the North_B router, which is a slow backup link. The administrator of ASN 64502 wants traffic from ASN 64501 to 10.0.0.0/8 to travel via the primary link, North_A. Which change to the network configuration accomplishes this task?

A. Set a higher local preference between North_A and South-A B. Set a lower MED between North_B and South_B C. Advertise the 10.0.0.0/8 prefix through North_B and specific subnets through North_A D. Set a lower Weight value for incoming traffic on North_A

Refer to the exhibit. Router 1 is missing the route for the router 2 loopback 0. What should the engineer change to fix the problem?

A. Router 1 to be an ABR B. the wildcard mask network statement in OSPF of Router 2 C. the hello timers on Router 1 and Router 2 to be different D. the area numbers on Router 1 and Router 2 to be similar

Refer to the exhibit. Which two topology changes happen to the IS-IS routers? (Choose two.)

A. R1 and R4 are Level 2 neighbors B. All four routers are operating as Level 1-2 routers C. All four routers are operating as Level 2 routers only D. R1 and R2 are Level 2 neighbors E. All four routers are operating as Level 1 routers only

An engineer is trying to implement BGP in a multihomed architecture. What must the engineer configure to influence inbound path selection?

A. A route map with AS-PATH attribute to control the inbound traffic B. An offset list to set the metric for routes received from neighboring autonomous systems C. An access list to identify traffic and enable it on both of the provider-facing interfaces D. A route map with WEIGHT attribute to control the inbound traffic

Refer to the exhibit. An engineer is updating this network to meet these conditions: -Area 10 will receive inter-area routes and support mutual redistribution of external routes with the extranet. -The ::/0 route is prohibited in Area 10. -Area 11 will receive only the ::/0 route from the ABR. -External route redistribution is not supported in Area 11. -The ABR in Area 11 will advertise no interarea routes. Which two configurations must be performed to meet the requirements? (Choose two.)

A. Configure area 10 as nssa on R9 and XR32 B. Configure area 11 as stub no-summary on R7 and as stub on XR31 C. Configure area 11 as nssa no-summary on R7 and as nssa on XR31 D. Configure area 11 as nssa default-information-originate on R7 and as nssa on XR31 E. Configure area 10 as stub on R9 and XR32

A network team has failed to implement IS-IS multitopology. What is the reason for it?

A. The routing process supported Level 1 only B. The router did not support VRFs C. The routing process did not support extended metrics D. The router did not have Cisco Discovery Protocol and Cisco Express Forwarding disabled

ASN 65001 is peering with ASN 65002 to exchange IPv6 BGP routes. All routes that originate in ASN 65001 have a standard community value of 65001:100, andASN 65002 is allowed to advertise only 2001:db8:aaaa::/48. An engineer needs to update the ASN 65001 route-filtering configuration to meet these conditions: -Looped routes into ASN 65001 and routes that have traversed 10 or more ASNs must be denied. -Routes accepted into ASN 65001 must be assigned a community value of 65001:200. Which configuration must be engineer apply to the ASN 65001 border router?

A. B. C. D.

Refer to the exhibit. An engineer needs to implement this QoS policy on customer's network due to ongoing slow network issues. What will be the effect on the network when the engineer implements this configuration?

A. Traffic that is identified in the ciscopolicy class map will be remarked from IP precedence 1 to DSCP AF11 when it exits the pos0/2/0/0 interface B. Traffic that is identified in the ciscotest class map will be marked with IP precedence 1 when it exits the pos0/2/0/0 interface C. Traffic that is identified in the ciscopolicy class map will be marked with IP precedence 1 when it enters the pos0/2/0/0 interface D. Traffic that is identified in the ciscotest class map will be remarked from IP precedence 1 to DSCP AF11 when it enters the pos0/2/0/0 interface

Refer to the exhibit. Router 4 is added to the network and must be in the same area as router 1. Which NET should the engineer assign?

A. 49.0111.0000.0000.0001.00 B. 49.0001.0000.0000.0004.00 C. 49.0011.0000.0000.0002.00 D. 49.0011.0000.0000.0003.00