Question 51
In Cisco SD-WAN, which protocol is used to measure link quality?
A. IPsec
B. OMP
C. RSVP
D. BFD Most Voted
Question 52
What is used to perform QoS packet classification?
A. the Type field in the Layer 2 frame
B. the Options field in the Layer 3 header
C. the TOS field in the Layer 3 header Most Voted
D. the Flags field in the Layer 3 header
Question 53
How do cloud deployments differ from on-premises deployments?
A. Cloud deployments require longer implementation times than on-premises deployments.
B. Cloud deployments are more customizable than on-premises deployments.
C. Cloud deployments have lower upfront costs than on-premises deployments.
D. Cloud deployments require less frequent upgrades than on-premises deployments.
Question 54
Which controller is capable of acting as a STUN server during the onboarding process of Edge devices?
A. vBond
B. vSmart
C. vManage
D. PNP Server
Question 55
How is 802.11 traffic handled in a fabric-enabled SSID?
A. centrally switched back to WLC where the user traffic is mapped to a VXLAN on the WLC
B. converted by the AP into 802.3 and encapsulated into VXLAN Most Voted
C. centrally switched back to WLC where the user traffic is mapped to a VLAN on the WLC
D. converted by the AP into 802.3 and encapsulated into a VLAN
Question 56
Refer to the exhibit.An engineer is installing a new pair of routers in a redundant configuration. When checking on the standby status of each router, the engineer notices that the routers are not functioning as expected.Which action will resolve the configuration error?
A. configure matching hold and delay timers
B. configure matching key-strings
C. configure matching priority values
D. configure unique virtual IP addresses Most Voted
Question 57
Refer to the exhibit.Router1 is currently operating as the HSRP primary with a priority of 110. Router1 fails and Router2 takes over the forwarding role. Which command on Router1 causes it to take over the forwarding role when it returns to service?
A. standby 2 priority
B. standby 2 preempt
C. standby 2 track
D. standby 2 timers
Question 58
An engineer has deployed a single Cisco 5520 WLC with a management IP address of 172 16.50.5/24. The engineer must register 50 new Cisco AIR-CAP2802I-E-K9 access points to the WLC using DHCP option 43. The access points are connected to a switch in VLAN 100 that uses the 172.16.100.0/24 subnet. The engineer has configured the DHCP scope on the switch as follows:Network 172.16.100.0 255.255.255.0Default Router 172.16.100.1 -Option 43 ASCII 172.16.50.5 -The access points are failing to join the wireless LAN controller. Which action resolves the issue?
A. configure option 43 Hex F104.AC10.3205 Most Voted
B. configure option 43 Hex F104.CA10.3205
C. configure dns-server 172.16.50.5
D. configure dns-server 172. 16.100.1
Question 59
What is the role of vSmart in a Cisco SD-WAN environment?
A. to establish secure control plane connections
B. to monitor, configure, and maintain SD-WAN devices
C. to provide secure data plane connectivity over WAN links
D. to perform initial authentication of devices
Question 60
Which action is performed by Link Management Protocol in a Cisco StackWise Virtual domain?
A. It determines which switch becomes active or standby.
B. It determines if the hardware is compatible to form the StackWise Virtual domain.
C. It rejects any unidirectional link traffic forwarding.
D. It discovers the StackWise domain and brings up SVL interfaces.
