Question 551
Refer to the exhibit. An engineer must protect the CPU of the router from high rates of NTP, SNMP, and SSH traffic
Which two configurations must be applied to drop these types of traffic when it continuously exceeds 320 kbps? (Choose two.)
A. R1(config-pmap)#class CLASS-CoPP-Management R1(config-pmap-c)#police 32 conform-action transmit exceed-action drop violate-action transmit
B. R1(config)#policy-map POLICY-CoPP R1(config-pmap)#class CLASS-CoPP-Management R1(config-pmap-c)#police 320000 conform-action transmit exceed-action drop violate-action drop
C. R1(config)#policy-map POLICY-CoPP R1(config-pmap)#class CLASS-CoPP-Management R1(config-pmap-c)#police 320000 conform-action transmit exceed-action transmit violate-action drop
D. R1(config)#control-plane R1(config-cp)# service-policy output POLICY-CoPP
E. R1(config)#control-plane R1(config-cp)# service-policy input POLICY-CoPP
Question 552
Which free application has the ability to make REST calls against Cisco DNA Center?
A. API Explorer
B. REST Explorer
C. Postman
D. Mozilla
Question 553
If AP power level is increased from 25 mW to 100 mW, what is the power difference in dBm?
A. 6 dBm
B. 14 dBm
C. 17 dBm
D. 20 dBm
Question 554
What is the result when an active route processor fails in a design that combines NSF with SSO?
A. The standby route processor temporarily forwards packets until route convergence is complete.
B. An NSF-aware device immediately updates the standby route processor RIB without churning the network.
C. An NSF-capable device immediately updates the standby route processor RIB without churning the network.
D. The standby route processor immediately takes control and forwards packets along known routes
Question 555
Refer to the exhibit
Which command is required to verify NETCONF capability reply messages?
A. show netconf rpc-reply
B. show netconf | section rpc-reply
C. show netconf schema | section rpc-reply
D. show netconf xml rpc-reply
Question 556
Refer to the exhibit. An engineer must configure an ERSPAN tunnel that mirrors traffic from Linux1 on Switch1 to Linux2 on Switch2
Which command must be added to the destination configuration to enable the ERSPAN tunnel?
A. (config-mon-erspan-dst-src)# erspan-id 172.16.10.10
B. (config mon erspan-dst-src)# erspan-id 110
C. (config-mon-erspan-dst-src)# no shut
D. (config-mon-erspan-dst-src)# origin ip address 172.16.10.10
Question 557
When is an external antenna used inside a building?
A. only when using Mobility Express
B. only when using 2.4 GHz
C. when it provides the required coverage
D. only when using 5 GHz
Question 558
Refer to the exhibit. R1 and R2 are directly connected, but the BGP session does not establish
Which action must be taken to build an eBGP session?
A. Configure no neighbor 192.168.12.1 shutdown under R2 BGP process.
B. Configure neighbor 2.2.2.2 remote-as 65002 under R1 BGP process.
C. Configure ip route 1.1.1.1 0.0.0.0 192.168.12.1 on R2.
D. Configure neighbor 192.168.12.1 activate under R2 BGP process.
Question 559
A company requires a wireless solution to support its main office and multiple branch locations. All sites have local Internet connections and a link to the main office for corporate connectivity. The branch offices are managed centrally
Which solution should the company choose?
A. Cisco DNA Spaces
B. Cisco Unified Wireless Network
C. Cisco Mobility Express
D. Cisco Catalyst switch with embedded controller
Question 560
Which QoS feature uses the IP Precedence bits in the ToS field of the IP packet header to partition traffic into different priority levels?
A. marking
B. shaping
C. policing
D. classification
