Refer to the exhibit.Which type of antenna does the radiation pattern represent?
A. multidirectional
B. directional patch
C. omnidirectional
D. Yagi
Question 152
Wireless users report frequent disconnections from the wireless network. While troubleshooting, a network engineer finds that after the user is disconnected, the connection re-establishes automatically without any input required. The engineer also notices these message logs:AP 'AP2' is down. Reason: Radio channel set. 6:54:04 PMAP 'AP4' is down. Reason: Radio channel set. 6:44:49 PMAP 'AP7' is down. Reason: Radio channel set. 6:34:32 PMWhich action reduces the user impact?
A. enable coverage hole detection
B. increase the AP heartbeat timeout
C. enable BandSelect
D. increase the dynamic channel assignment interval
Question 153
Refer to the exhibit.The inside and outside interfaces in the NAT configuration of this device have been correctly identified.What is the effect of this configuration?
A. NAT64
B. dynamic NAT
C. static NAT
D. PAT
Question 154
DRAG DROP -Drag and drop the descriptions from the left onto the routing protocol they describe on the right.Select and Place:
Question 155
What is the purpose of an RP in PIM?
A. send join messages toward a multicast source SPT Most Voted
B. ensure the shortest path from the multicast source to the receiver
C. receive IGMP joins from multicast receivers
D. secure the communication channel between the multicast sender and receiver
Question 156
Refer to the exhibit. Which command must be applied to R2 for an OSPF neighborship to form?
A. network 20.1.1.2 255.255.0.0 area 0
B. network 20.1.1.2 0.0.0.0 area 0 Most Voted
C. network 20.1.1.2 255.255.255.255 area 0
D. network 20.1.1.2 0.0.255.255 area 0
Question 157
Refer to the exhibit. Which router is the designated router on the segment 192.168.0.0/24?
A. This segment has no designated router because it is a p2p network type.
B. Router Chicago because it has a lower router ID.
C. Router NewYork because it has a higher router ID.
D. This segment has no designated router because it is a nonbroadcast network type.
Question 158
Refer to the exhibit. Which two commands are needed to allow for full reachability between AS 1000 and AS 2000? (Choose two.)
A. R2#no network 10.0.0.0 255.255.255.0
B. R2#network 209.165.201.0 mask 255.255.192.0
C. R2#network 192.168.0.0 mask 255.255.0.0
D. R1#no network 10.0.0.0 255.255.255.0
E. R1#network 192.168.0.0 mask 255.255.0.0
Question 159
Refer to the exhibit. An engineer attempts to configure a router on a stick to route packets between Clients, Servers, and Printers; however, initial tests show that this configuration is not working. Which command set resolves this issue?
A. interface Vlan10 no ip vrf forwarding Clients ! interface Vlan20 no ip vrf forwarding Servers ! interface Vlan30 no ip vrf forwarding Printers
C. interface Vlan10 no ip vrf forwarding Clients ip address 192.168.1.1. 255.255.255.0 ! interface Vlan20 no ip vrf forwarding Servers ip address 172.16.1.1 255.255.255.0 ! interface Vlan30 no ip vrf forwarding Printers ip address 10.1.1.1 255.255.255.0
