Question 91
What is required for a virtual machine to run?
A. a Type 1 hypervisor and a host operating system
B. a hypervisor and physical server hardware
C. only a Type 1 hypervisor
D. only a Type 2 hypervisor
Question 92
Which entity is a Type 1 hypervisor?
A. Oracle VM VirtualBox
B. Citrix XenServer
C. VMware server
D. Microsoft Virtual PC
Question 93
What are two benefits of virtual switching when compared to hardware switching? (Choose two.)
A. increased MTU size
B. VM-level isolation
C. extended 802.1Q VLAN range
D. hardware independence Most Voted
E. increased flexibility Most Voted
Question 94
What is a characteristic of a virtual machine?
A. It must run the same operating system as its host.
B. It is deployable without a hypervisor to host it.
C. It must be aware of other virtual machines, in order to allocate physical resources for them.
D. It relies on hypervisors to allocate computing resources for it.
Question 95
Which LISP component is required for a LISP site to communicate with a non-LISP site?
A. Proxy ITR
B. ITR
C. ETR
D. Proxy ETR Most Voted
Question 96
Which two components are supported by LISP? (Choose two.)
A. proxy ETR
B. egress tunnel router
C. route reflector
D. HMAC algorithm
E. spoke
Question 97
What is the function of a VTEP in VXLAN?
A. provide the routing underlay and overlay for VXLAN headers
B. dynamically discover the __cpLocation of end hosts in a VXLAN fabric
C. encapsulate and de-encapsulate traffic into and out of the VXLAN fabric
D. statically point to end host __cpLocations of the VXLAN fabric
Question 98
Refer to the exhibit. Which configuration must be applied to R1 to enable R1 to reach the server at 172.16.0.1?
A. interface Ethernet0/0 ip address 172.16.0.7 255.255.0.0 router ospf 44 vrf bank network 172.16.0.0 255.255.0.0
B. interface Ethernet0/0 vrf forwarding hotel ip address 172.16.0.7 255.255.0.0 router ospf 44 vrf Hotel network 172.16.0.0 0.0.255.255 area 0
C. interface Ethernet0/0 vrf forwarding bank ip address 172.16.0.7 255.255.0.0 router ospf 44 vrf bank network 172.16.0.0 0.0.255.255 area 0
D. interface Ethernet0/0 ip address 172.16.0.7 255.255.0.0 router ospf 44 vrf hotel network 172.16.0.0 255.255.0.0
Question 99
Refer to the exhibit. Which configuration allows Customer2 hosts to access the FTP server of Customer1 that has the IP address of 192.168.1.200?
A. ip route vrf Customer1 172.16.1.0 255.255.255.0 172.16.1.1 global ip route vrf Customer2 192.168.1.200 255.255.255.255 192.168.1.1 global ip route 192.168.1.0 255.255.255.0 Vlan10 ip route 172.16.1.0 255.255.255.0 Vlan20
B. ip route vrf Customer1 172.16.1.1 255.255.255.255 172.16.1.1 global ip route vrf Customer2 192.168.1.200 255.255.255.0 192.168.1.1 global ip route 192.168.1.0 255.255.255.0 Vlan10 ip route 172.16.1.0 255.255.255.0 Vlan20
C. ip route vrf Customer1 172.16.1.0 255.255.255.0 172.16.1.1 Customer2 ip route vrf Customer2 192.168.1.200 255.255.255.255 192.168.1.1 Customer1
D. ip route vrf Customer1 172.16.1.0 255.255.255.0 172.16.1.1 Customer1 ip route vrf Customer2 192.168.1.200 255.255.255.255 192.168.1.1 Customer2
Question 100
Refer to the exhibit. A network engineer configures a new GRE tunnel and enters the show run command. What does the output verify?
A. The tunnel keepalive is configured incorrectly because they must match on both sites.
B. The tunnel destination will be known via the tunnel interface. Most Voted
C. The tunnel will be established and work as expected.
D. The default MTU of the tunnel interface is 1500 bytes.
