Win IT Exam with Last Dumps 2024


Cisco 300-425 Exam

Page 11/11
Viewing Questions 101 106 out of 106 Questions
100.00%

Question 101
A wireless engineer must optimize RF performance for multiple buildings with multiple types of construction and user density. Which two actions must be taken?(Choose two.)
A. Configure FlexConnect groups for each building.
B. Configure WMM profiles for each building.
C. Configure AP groups for each area type.
D. Configure RF profiles for each area type.
E. Enable DTPC on the network.

Question 102
How does AP failover priority for access points function when configured with priority 1 or 4?
A. When configured with priority 1, the access point is assigned with the highest priority level, and it is marked as critical. This access point fails over before other access points with the lower priority when there is primary controller failure.
B. When configured with priority 4, the access point is assigned with the highest priority level, and it is marked as critical. This access point fails over before other access points with the lower priority when there is primary controller failure.
C. When configured with priority 4, the access point is assigned with the lowest priority level, and it is marked as low. This access point fails over after other access points with the higher priority when there is primary controller failure.
D. When configured with priority 1, the access point is assigned with the medium priority level, and it is marked as medium. This access point fails over after other access points with the higher priority when there is primary controller failure.

Question 103
A company has 10 access point licenses available on their backup Cisco WLC, and their primary Cisco WLC is at full capacity. 5 access points are set to high failover priority and 7 access points are set to critical failover priority. During a failure, not all critical access points failed over to the backup Cisco WLC. Which configuration is the cause of this issue?
A. The high priority access point is oversubscribed.
B. network ap-priority is set to enable.
C. The critical priority access point count is oversubscribed.
D. network ap-priority is set to disable.

Question 104
A network engineer is configuring high availability on an access point. What is the maximum number of controllers available to be configured?
A. 1
B. 2
C. 3
D. 4

Question 105
An engineer is trying to determine the most cost-effective way to deploy high availability for a campus enterprise wireless network that currently leverages three wireless LAN controllers. Which architecture should the engineer deploy?
A. N+N with SSO
B. N+1 solution without SSO
C. N+N solution without SSO
D. N+1 with SSO


Question 106
A customer has multiple WLCs running N+1 redundancy with APs equally distributed. Only one WLC is a designated backup for all other WLCs so the customer must ensure that the most critical APs remain registered or get priority over other APs in case of a WLC failure. However, the customer notices on WLC failure that some critical APs remain unregistered What needs to be addressed in the design?
A. AP fallback is not enabled on the backup WLC.
B. AP failover priority is not enabled globally on the backup WLC.
C. AP failover priority is not enabled globally on the failed WLC.
D. AP fallback is not enabled on the failed WLC.



Premium Version