Question 51
Which set of elements are verified by the controller to confirm the identity of edge devices?
A. certificates, organization name, and serial number of the device
B. organization name, serial number, and system IP of the device
C. certificates, organization name, and vBond domain
D. certificates, system IP, and vBond domain
Question 52
Refer to the exhibit. vManage and vBond have an issue establishing a connection with each other. Which action resolves the issue?
A. Change the organization name on both controllers to match viptela.com.
B. Configure the encapsulation ipsec command under the tunnel interface on vManage.
C. Reconfigure the system IPs to belong to the same subnet.
D. Remove the encapsulation ipsec command under the tunnel interface of vBond.
Question 53
Refer to the exhibit. An engineer is getting a CTORGNMMIS error on a controller connection. Which action resolves this issue?
A. Configure a valid certificate on vSMART.
B. Configure a valid organization name.
C. Configure a valid serial number on the WAN Edge.
D. Configure a valid product ID.
Question 54
Refer to the exhibit. A small company was acquired by a large organization. As a result, the new organization decided to update information on their Enterprise RootCA and generated a new certificate using openssl. Which configuration updates the new certificate and issues an alert in vManage Monitor | Events Dashboard?
A.
B.
C.
D.
Question 55
DRAG DROP - Drag and drop the vManage policy configuration procedures from the left onto the correct definitions on the right. Select and Place:
Question 56
A vEdge platform is sending VRRP advertisement messages every 10 seconds. Which value configures the router back to the default timer?
A. 2 seconds
B. 5 seconds
C. 1 second
D. 3 seconds
Question 57
Which OSPF command makes the WAN Edge router a less preferred exit from a site with a dual WAN Edge design?
A.
B.
C.
D.
Question 58
Which two services are critical for zero touch provisioning on-boarding? (Choose two.)
A. EMAIL
B. SNMP
C. AAA
D. DHCP
E. DNS
Question 59
When redistribution is configured between OMP and BGP at two Data Center sites (DC) that have Direct Connection Interlink, which step avoids learning the same routes on WAN Edge routers of the DCs from LAN?
A. Set down-bit on WAN Edge routers on DC1
B. Define different VRFs on both DCs
C. Set OMP admin distance lower than BGP admin distance
D. Set same overlay AS on both DC WAN Edge routers
Question 60
Which device information is required on PNP/ZTP to support the zero touch onboarding process?
A. serial and chassis numbers
B. interface IP address
C. public DNS entry
D. system IP address
