Refer to the exhibit. A network administrator is configuring OMP in vManage to advertise all the paths for the same prefix from a site that has two WAN Edge devices. Each WAN Edge device is connected to three ISPs and two private MPLS transports. What is the minimum value for `Number of Paths advertised perPrefix` that should be configured?
A. 2
B. 3
C. 5
D. 10
Question 192
Refer to the exhibit. A network administrator is setting the queueing value for voice traffic for one of the WAN Edge routers using vManager GUI. Which queue value be set to accomplish this task?
A. 0
B. 1
C. 2
D. 3
Question 193
An engineer is configuring a shaping rate of 1 Mbps on the WAN Edge router. Which configuration accomplishes this task?
A.
B.
C.
D.
Question 194
Which value is verified in the certificates to confirm the identity of the physical WAN Edge device?
A. Serial Number
B. OTP
C. System-IP
D. Chassis-ID
Question 195
A network administrator is configuring QoS on a WAN Edge 5000 router and needs to enable it on the transport side interface. Which policy setting must be selected to accomplish this goal?
A. Cloud QoS
B. Netflow
C. Application
D. Cloud QoS Service side
Question 196
What is a benefit of the application-aware firewall feature in the Cisco SD-WAN solution?
A. application visibility
B. control policy enforcement
C. application monitoring
D. application malware protection
Question 197
An engineer is configuring a WAN Edge router for DIA based on matching QoS parameters. Which two actions accomplish this task? (Choose two.)
A. Apply a data policy on WAN interface
B. Configure a control policy
C. Apply a QoS map policy
D. Configure NAT on the transport interface
E. Configure a centralized data policy
Question 198
Refer to the exhibit. The ge0/0 interface connects to a 30-MB link. A network administrator wants to always have 10 MB available for high priority traffic. When lower-priority traffic bursts exceed 20 MB, traffic should be redirected to the second WAN interface ge0/1. Which set of configurations accomplishes this task?
A.
B.
C.
D.
Question 199
Refer to the exhibit. Which shaping-rate does the engineer use to shape traffic at 9 Mbps?
A. 9
B. 9000
C. 90000
D. 9000000
Question 200
An engineer is configuring a shaping rate of 1 Mbps on the WAN link of a WAN Edge router. Which configuration accomplishes this task?
