Win IT Exam with Last Dumps 2024

Which set of elements are verified by the controller to confirm the identity of edge devices?

A. certificates, organization name, and serial number of the device B. organization name, serial number, and system IP of the device C. certificates, organization name, and vBond domain D. certificates, system IP, and vBond domain

Refer to the exhibit. vManage and vBond have an issue establishing a connection with each other. Which action resolves the issue?

A. Change the organization name on both controllers to match viptela.com. B. Configure the encapsulation ipsec command under the tunnel interface on vManage. C. Reconfigure the system IPs to belong to the same subnet. D. Remove the encapsulation ipsec command under the tunnel interface of vBond.

Refer to the exhibit. An engineer is getting a CTORGNMMIS error on a controller connection. Which action resolves this issue?

A. Configure a valid certificate on vSMART. B. Configure a valid organization name. C. Configure a valid serial number on the WAN Edge. D. Configure a valid product ID.

Refer to the exhibit. A small company was acquired by a large organization. As a result, the new organization decided to update information on their Enterprise RootCA and generated a new certificate using openssl. Which configuration updates the new certificate and issues an alert in vManage Monitor | Events Dashboard?

A. B. C. D.

DRAG DROP - Drag and drop the vManage policy configuration procedures from the left onto the correct definitions on the right. Select and Place:

A vEdge platform is sending VRRP advertisement messages every 10 seconds. Which value configures the router back to the default timer?

A. 2 seconds B. 5 seconds C. 1 second D. 3 seconds

Which OSPF command makes the WAN Edge router a less preferred exit from a site with a dual WAN Edge design?

A. B. C. D.

Which two services are critical for zero touch provisioning on-boarding? (Choose two.)

A. EMAIL B. SNMP C. AAA D. DHCP E. DNS

When redistribution is configured between OMP and BGP at two Data Center sites (DC) that have Direct Connection Interlink, which step avoids learning the same routes on WAN Edge routers of the DCs from LAN?

A. Set down-bit on WAN Edge routers on DC1 B. Define different VRFs on both DCs C. Set OMP admin distance lower than BGP admin distance D. Set same overlay AS on both DC WAN Edge routers

Which device information is required on PNP/ZTP to support the zero touch onboarding process?

A. serial and chassis numbers B. interface IP address C. public DNS entry D. system IP address