Refer to the exhibit. A network administrator successfully logs in to a switch using SSH from a RADIUS server. When the network administrator uses a console port to access the switch, the RADIUS server returns shell:priv-lvl=15" and the switch asks to enter the enable command. When the command is entered, it gets rejected. Which command set is used to troubleshoot and resolve this issue?
Question 162
Refer to the exhibit. An engineer is troubleshooting a TACACS problem. Which action resolves the issue?
Question 163
The network administrator configured CoPP so that all HTTP and HTTPS traffic from the administrator device located at 172.16 1.99 toward the router CPU is limited to 500 kbps. Any traffic that exceeds this limit must be dropped.
Question 164
Refer to the exhibit. While monitoring VTY access to a router, an engineer notices that the router does not have any filter and anyone can access the router with username and password even though an ACL is configured. Which command resolves this issue?
Question 165
Refer to the exhibit. An engineer is trying to connect to R1 via Telnet with no success. Which configuration resolves the issue?
Question 166
An engineer is trying to copy an IOS file from one router to another router by using TFTP. Which two actions are needed to allow the file to copy? (Choose two.)
Question 167
Refer to the exhibit. Users report that IP addresses cannot be acquired from the DHCP server. The DHCP server is configured as shown. About 300 total nonconcurrent users are using this DHCP server, but none of them are active for more than two hours per day. Which action fixes the issue within the current resources?
Question 168
Refer to the exhibit. ISP 1 and ISP 2 directly connect to the Internet. A customer is tracking both ISP links to achieve redundancy and cannot see the Cisco IOS IPSLA tracking output on the router console. Which command is missing from the IP SLA configuration?
Question 169
Refer to the exhibit. An administrator noticed that after a change was made on R1, the timestamps on the system logs did not match the clock. What is the reason for this error?
Question 170
DRAG DROP -Drag and drop the DHCP messages from the left onto the correct uses on the right. Select and Place:
