Win IT Exam with Last Dumps 2024

Refer to the exhibit. Router R2 is configured with multiple routes to reach network 10.1.1.0/24 from router R1. Which path is chosen by router R2 to reach the destination network 10.1.1.0/24?

A. static

B. EIGRP

C. eBGP

D. OSPF

Refer to the exhibit. What is the next hop address for traffic that is destined to host 10.0.1.5?

A. Loopback 0

B. 10.0.1.4

C. 10.0.1.3

D. 10.0.1.50

Refer to the exhibit. A network administrator assumes a task to complete the connectivity between PC A and the File Server. Switch A and Switch B have been partially configured with VLANs 10, 11, 12, and 13. What is the next step in the configuration?

A. Add PC A to VLAN 10 and the File Server to VLAN 11 for VLAN segmentation

B. Add VLAN 13 to the trunk links on Switch A and Switch B for VLAN propagation

C. Add a router on a stick between Switch A and Switch B allowing for Inter-VLAN routing

D. Add PC A to the same subnet as the File Server allowing for intra-VLAN communication

DRAG DROP -A network engineer is configuring an OSPFv2 neighbor adjacency. Drag and drop the parameters from the left onto their required categories on the right. Not all parameters are used.
Select and Place:

R1 has learned route 192.168.12.0/24 via IS-IS, OSPF, RIP, and Internal EIGRP. Under normal operating conditions, which routing protocol is installed in the routing table?

A. IS-IS

B. Internal EIGRP

C. RIP

D. OSPF

Refer to the exhibit. The default-information originate command is configured under the R1 OSPF configuration. After testing, workstations on VLAN 20 at SiteB cannot reach a DNS server on the Internet.
Which action corrects the configuration issue?

A. Add the default-information originate command on R2.

B. Add the always keyword to the default-information originate command on R1.

C. Configure the ip route 0.0.0.0 0.0.0.0 10.10.10.18 command on R1.

D. Configure the ip route 0.0.0.0 0.0.0.0 10.10.10.2 command on R2.

Refer to the exhibit. With which metric was the route to host 172.16.0.202 learned?

A. 0

B. 110

C. 38443

D. 3184439

A user configured OSPF in a single area between two routers. A serial interface connecting R1 and R2 is running encapsulation PPP. By default, which OSPF network type is seen on this interface when the user types show ip ospf interface on R1 or R2?

A. nonbroadcast

B. point-to-point

C. point-to-multipoint

D. broadcast

Which MAC address is recognized as a VRRP virtual address?

A. 0000.5E00.010a

B. 0005.3709.8968

C. 0000.0C07.AC99

D. 0007.C070.AB01

A router running EIGRP has learned the same route from two different paths. Which parameter does the router use to select the best path?

A. as-path

B. administrative distance

C. metric

D. cost