Question 331
What is a function of MAC learning on a switch?
A. MAC address learning is disabled by default on all VLANs.
B. Frames received for a destination MAC address not listed in the address table are dropped.
C. The MAC address table is used to populate the ARP table.
D. A static MAC address is manually added to the MAC table.
Question 332
What does a switch do when it receives a frame whose destination MAC address is missing from the MAC address table?
A. It changes the checksum of the frame to a value that indicates an invalid frame.
B. It updates the CAM table with the destination MAC address of the frame.
C. It appends the table with a static entry for the MAC and shuts down the port.
D. It floods the frame unchanged across all remaining ports in the incoming VLAN.
Question 333
By default, how long will the switch continue to know a workstation MAC address after the workstation stops sending traffic?
A. 200 seconds
B. 300 seconds
C. 600 seconds
D. 900 seconds
Question 334
A project objective is to minimize the association time to the different access points as mobile devices move around the office. The ideal solution must cover numerous devices and device types, including laptops, mobile phones, tablets and wireless printers. What must be configured?
A. 802.11v BSS Max Idle Service
B. 802.11v Disassociation Imminent
C. 802.11ax BSS configure
D. 802.11k neighbor List Dual Band
Question 335
Which two protocols are used by an administrator for authentication and configuration on access points? (Choose two.)
A. 802.1Q
B. RADIUS
C. Kerberos
D. TACACS+
E. 802.1x
Question 336
DRAG DROP - Drag and drop the statements about access-point modes from the left onto the corresponding modes on the right. Select and Place:
Question 337
A WLC sends alarms about a rogue AP, and the network administrator verifies that the alarms are caused by a legitimate autonomous AP. How must the alarms be stopped for the MAC address of the AP?
A. Remove the AP from WLC management
B. Place the AP into manual containment.
C. Manually remove the AP from Pending state.
D. Set the AP Class Type to Friendly.
Question 338
What is one reason to implement LAG on a Cisco WLC?
A. to increase security and encrypt management frames
B. to enable connected switch ports to failover and use different VLANs
C. to provide link redundancy and load balancing
D. to allow for stateful and link-state failover
Question 339
When an access point is seeking to join wireless LAN controller, which message is sent to the AP-Manager interface?
A. Discovery response
B. DHCP request
C. DHCP discover
D. Discovery request
Question 340
Refer to the exhibit. A network engineer configures the Cisco WLC to authenticate local wireless clients against a RADIUS server. Which task must be performed to complete the process?
A. Change the Support for CoA to Enabled
B. Select Enable next to Management
C. Select Enable next to Network User
D. Change the Server Status to Disabled
