Question 211
Which two pieces of information about a Cisco device can Cisco Discovery Protocol communicate? (Choose two.)
A. the native VLAN
B. the trunking protocol
C. the VTP domain
D. the spanning-tree priority
E. the spanning-tree protocol
Question 212
After you deploy a new WLAN controller on your network, which two additional tasks should you consider? (Choose two.)
A. deploy load balancers
B. configure additional vlans
C. configure multiple VRRP groups
D. deploy POE switches
E. configure additional security policies
Question 213
Refer to the exhibit. How will switch SW2 handle traffic from VLAN 10 on SW1?
A. It sends the traffic to VLAN 10.
B. It sends the traffic to VLAN 100.
C. It drops the traffic.
D. It sends the traffic to VLAN 1.
Question 214
Which two commands can you use to configure an actively negotiate EtherChannel? (Choose two.)
A. channel-group 10 mode on
B. channel-group 10 mode auto
C. channel-group 10 mode passive
D. channel-group 10 mode desirable
E. channel-group 10 mode active
Question 215
How does STP prevent forwarding loops at OSI Layer 2?
A. TTL
B. MAC address forwarding
C. Collision avoidance
D. Port blocking
Question 216
A. All switches must be configured with the same VTP domain name
B. All switches must be configured to perform trunk negotiation
C. All switches must be configured with a unique VTP domain name
D. The VTP server must have the highest revision number in the domain
E. All switches must use the same VTP version
Question 217
Which type does a port become when it receives the best BPDU on a bridge?
A. The designated port
B. The backup port
C. The alternate port
D. The root port
Question 218
Which value can you modify to configure a specific interface as the preferred forwarding interface?
A. The interface number
B. The port priority
C. The VLAN priority
D. The hello time
Question 219
Which statement about Cisco Discovery Protocol is true?
A. It is a Cisco-proprietary protocol.
B. It runs on the network layer.
C. It can discover information from routers, firewalls, and switches.
D. It runs on the physical layer and the data link layer.
Question 220
What are two reasons a network administrator would use CDP? (Choose two.)
A. to verify the type of cable interconnecting two devices
B. to determine the status of network services on a remote device
C. to obtain VLAN information from directly connected switches
D. to verify Layer 2 connectivity between two devices when Layer 3 fails
E. to obtain the IP address of a connected device in order to telnet to the device
F. to determine the status of the routing protocols between directly connected routers
