Question 11
When configuring IPv6 on an interface, which two IPv6 multicast groups are joined? (Choose two.)
A. 2000::/3
B. 2002::5
C. FC00::/7
D. FF02::1
E. FF02::2
Question 12
DRAG DROP -Refer to the exhibit. Drag and drop the networking parameters from the left onto the correct values on the right.Select and Place:
Question 13
What is the default behavior of a Layer 2 switch when a frame with an unknown destination MAC address is received?
A. The Layer 2 switch forwards the packet and adds the destination MAC address to its MAC address table.
B. The Layer 2 switch sends a copy of a packet to CPU for destination MAC address learning.
C. The Layer 2 switch floods packets to all ports except the receiving port in the given VLAN.
D. The Layer 2 switch drops the received frame.
Question 14
An engineer must configure a /30 subnet between two routes. Which usable IP address and subnet mask combination meets this criteria?
A. interface e0/0 description to XX-AXXX:XXXXX ip address 10.2.1.3 255.255.255.252
B. interface e0/0 description to XX-AXXX:XXXXX ip address 192.168.1.1 255.255.255.248
C. interface e0/0 description to XX-AXXX:XXXXX ip address 172.16.1.4 255.255.255.248
D. interface e0/0 description to XX-AXXX:XXXXX ip address 209.165.201.2 225.255.255.252
Question 15
Which network allows devices to communicate without the need to access the Internet?
A. 172.9.0.0/16
B. 172.28.0.0/16
C. 192.0.0.0/8
D. 209.165.201.0/24
Question 16
Refer to the exhibit. Which statement explains the configuration error message that is received?
A. It belongs to a private IP address range.
B. The router does not support /28 mask.
C. It is a network IP address.
D. It is a broadcast IP address.
Question 17
Which IPv6 address type provides communication between subnets and cannot route on the Internet?
A. link-local
B. unique local
C. multicast
D. global unicast
Question 18
Which IPv6 address block sends packets to a group address rather than a single address?
A. 2000::/3
B. FC00::/7
C. FE80::/10
D. FF00::/8
Question 19
What are two reasons that cause late collisions to increment on an Ethernet interface? (Choose two.)
A. when Carrier Sense Multiple Access/Collision Detection is used
B. when one side of the connection is configured for half-duplex
C. when the sending device waits 15 seconds before sending the frame again
D. when a collision occurs after the 32nd byte of a frame has been transmitted
E. when the cable length limits are exceeded
Question 20
What is a benefit of using a Cisco Wireless LAN Controller?
A. It eliminates the need to configure each access point individually.
B. Central AP management requires more complex configurations.
C. Unique SSIDs cannot use the same authentication method.
D. It supports autonomous and lightweight APs.
