Question 171
What is the path for traffic sent from one user workstation to another workstation on a separate switch in a three-tier architecture model?
A. access – core – distribution – access
B. access – distribution – distribution – access
C. access – core – access
D. access -distribution – core – distribution – access
Question 172
What is the difference between IPv6 unicast and anycast addressing?
A. An individual IPv6 unicast address is supported on a single interface on one node, but an IPv6 anycast address is assigned to a group of interfaces on multiple nodes.
B. IPv6 anycast nodes must be explicitly configured to recognize the anycast address, but IPv6 unicast nodes require no special configuration.
C. IPv6 unicast nodes must be explicitly configured to recognize the unicast address, but IPv6 anycast nodes require no special configuration.
D. Unlike an IPv6 anycast address, an IPv6 unicast address is assigned to a group of interfaces on multiple nodes.
Question 173
Refer to the exhibit. Between which zones do wireless users expect to experience intermittent connectivity?
A. between zones 1 and 2
B. between zones 2 and 5
C. between zones 3 and 4
D. between zones 3 and 6
Question 174
Which WAN topology provides a combination of simplicity quality, and availability?
A. partial mesh
B. full mesh
C. point-to-point
D. hub-and-spoke
Question 175
DRAG DROP - Drag and drop the statements about wireless architectures from the left onto the architectures on the right. Select and Place:
Question 176
DRAG DROP - Drag and drop the Wi-Fi terms from the left onto the descriptions on the right. Select and Place:
Question 177
How are the switches in a spine-and-leaf topology interconnected?
A. Each leaf switch is connected to one of the spine switches
B. Each leaf switch is connected to each spine switch.
C. Each leaf switch is connected to two spine switches, making a loop.
D. Each leaf switch is connected to a central leaf switch, then uplinked to a core spine switch.
Question 178
What is the primary effect of the spanning-tree portfast command?
A. It immediately enables the port in the listening state.
B. It immediately puts the port into the forwarding state when the switch is reloaded.
C. It enables BPDU messages.
D. It minimizes spanning-tree convergence time.
Question 179
What occurs when PortFast is enabled on an interface that is connected to another switch?
A. Root port choice and spanning-tree recalculation are accelerated when a switch link goes down.
B. After spanning-tree converges, PortFast shuts down any port that receives BPDUs.
C. VTP is allowed to propagate VLAN configuration information from switch to switch automatically.
D. Spanning-tree fails to detect a switching loop increasing the likelihood of broadcast storms.
Question 180
Which QoS Profile is selected in the GUI when configuring a voice over WLAN deployment?
A. Platinum
B. Bronze
C. Gold
D. Silver
