Win IT Exam with Last Dumps 2024


Cisco 200-301 Exam

Page 14/112
Viewing Questions 131 140 out of 1114 Questions
12.50%

Question 131
DRAG DROP - Drag and drop the IPv6 address type characteristics from the left to the right. Select and Place:
Image 200-301_131Q.png related to the Cisco 200-301 Exam
Image 200-301_131R.png related to the Cisco 200-301 Exam

Question 132
Refer to the exhibit. The IP address configurations must be completed on the DC-1 and HQ-1 routers based on these requirements: DC-1 Gi1/0 must be the last usable address on a /30, DC-1 Gi1/1 must be the first usable address on a /29, DC-1 Gi1/2 must be the last usable address on a /28, HQ-1 Gi1/3 must be the last usable address on a /29 Drag and drop the commands from the left onto the destination interfaces on the right. Not all commands are used. Select and Place:
Image 200-301_132Q.png related to the Cisco 200-301 Exam
Image 200-301_132R.png related to the Cisco 200-301 Exam

Question 133
How is RFC 1918 addressing used in a network?
A. They are used to access the Internet from the internal network without conversion.
B. They are used in place of public addresses for Increased security.
C. They are used with NAT to preserve public IPv4 addresses.
D. They are used by Internet Service Providers to route over the Internet.

Question 134
DRAG DROP - Drag and drop the IPv6 address types from the left onto their descriptions on the right. Select and Place:
Image 200-301_134Q.png related to the Cisco 200-301 Exam
Image 200-301_134R.png related to the Cisco 200-301 Exam

Question 135
Refer to the exhibit. What is a reason for poor performance on the network interface?
Image 200-301_135Q.png related to the Cisco 200-301 Exam
A. The interface is receiving excessive broadcast traffic.
B. The bandwidth setting of the interface is misconfigured.
C. The cable connection between the two devices is faulty.
D. The interface is operating at a different speed than the connected device.


Question 136
DRAG DROP - Drag and drop the IPv6 address descriptions from the left onto the IPv6 address types on the right. Not all options are used. Select and Place:
Image 200-301_136Q.png related to the Cisco 200-301 Exam
Image 200-301_136R.png related to the Cisco 200-301 Exam

Question 137
DRAG DROP - Drag and drop the IPv6 addresses from the left onto the corresponding address types on the right. Select and Place:
Image 200-301_137Q.png related to the Cisco 200-301 Exam
Image 200-301_137R.png related to the Cisco 200-301 Exam

Question 138
Which WAN topology has the highest degree of reliability?
A. point-to-point
B. router-on-a-stick
C. full mesh
D. hub-and-spoke

Question 139
DRAG DROP - Drag and drop the IPv6 address type characteristics from the left to the right. Select and Place:
Image 200-301_139Q.png related to the Cisco 200-301 Exam
Image 200-301_139R.png related to the Cisco 200-301 Exam

Question 140
What causes a port to be placed in the err-disabled state?
A. nothing plugged into the port
B. link flapping
C. latency
D. shutdown command issued on the port



Premium Version