What is a characteristic of encryption in wireless networks?
A. provides increased protection against spyware
B. prompts a user for a login ID
C. uses ciphers to detect and prevent zero-day network attacks
D. prevents the interception of data as it transits a network
Question 1032
What is a characteristic of an SSID in wireless networks?
A. intercepts data threats before they attack a network
B. encodes connections at the sending and receiving ends
C. broadcasts a beacon signal to announce its presence by default
D. identifies an access point on a WLAN
Question 1033
Refer to the exhibit. SW2 is replaced because of a hardware failure. A network engineer starts to configure SW2 by copying the fa0/1 interface configuration from SW1. Which command must be configured on the fa0/1 interface of SW2 to enable PC1 to connect to PC2?
A. switchport mode trunk
B. switchport trunk native vlan 10
C. switchport mode access
D. switchport trunk allowed remove 10
Question 1034
DRAG DROP -Drag and drop the DHCP snooping terms from the left onto the descriptions on the right.
Question 1035
What is a characteristic of private IPv4 addressing?
A. composed of up to 65,536 available addresses
B. issued by IANA in conjunction with an autonomous system number
C. used without tracking or registration
D. traverse the Internet when an outbound ACL is applied
Question 1036
DRAG DROP -Drag and drop the characteristic from the left onto the IPv6 address type on the right.
Question 1037
DRAG DROP -Drag and drop the characteristic from the left onto the cable type on the right.
Question 1038
How does MAC learning function on a switch?
A. broadcasts frames to all ports without queueing
B. sends an ARP request to locate unknown destinations
C. adds unknown source MAC addresses to the address table
D. sends a retransmission request when a new frame is received
Question 1039
Which interface condition is occurring in this output?
A. broadcast storm
B. collisions
C. high throughput
D. duplex mismatch
Question 1040
What is a characteristic of an SSID in wireless networks?
A. converts electrical current to radio waves
B. uses policies to prevent unauthorized users
C. broadcasts a beacon signal to announce its presence by default