DRAG DROP -Refer to the exhibit. OSPF is running between site A and site B. Drag and drop the destination IPs from the left onto the network segments used to reach the destination on the right.
Question 902
Refer to the exhibit. Routers R1 and R2 are configured with RIP as the dynamic routing protocol. A network engineer must configure R1 with a floating static route to service as a backup route to network 192.168.23. which command must the engineer configure on R1?
Question 903
When deploying a new network that includes both Cisco and third-party network devices, which redundancy protocol avoids the interruption of network traffic if the default gateway router fails?
Question 904
Which two IPv6 addresses are used to provide connectivity between two routers on a shared link? (Choose two.)
Question 905
DRAG DROP -Refer to the exhibit. Drag and drop the learned prefixes from the left onto the subnet masks on the right.
Question 906
Refer to the exhibit. Which action is taken by the router when a packet is sourced from 10.10.10.2 and destined for 10.10.10.16?
Question 907
DRAG DROP -Refer to the exhibit. The Router1 routing table has multiple methods to reach 10.10.10.0/24 as shown. The default Administrative Distance is used. Drag and drop the network conditions from the left onto the routing methods that Router1 uses on the right.
Question 908
An engineer must configure a core router with a floating static default route to the backup router at 10.200.0.2. Which command meets the requirements?
Question 909
Refer to the exhibit. Packets are flowing from 192.168.10.1 to the destination at IP address 192.168.20.75. Which next hop will the router select for the packet?
Question 910
A router received three destination prefixes: 10.0.0.0/8, 10.0.0.0/16, and 10.0.0.0/24. When the show ip route command is executed, which output does it return?
