Win IT Exam with Last Dumps 2025

A router has two static routes to the same destination network under the same OSPF process. How does the router forward packets to the destination if the net- hop devices are different?

A. The router chooses the route with the oldest age. B. The router chooses the next hop with the lowest IP address. C. The router chooses the next hop with the lowest MAC address. D. The router load-balances traffic over all routes to the destination.

Which feature or protocol is required for an IP SLA to measure UDP jitter?

A. LLDP B. EEM C. CDP D. NTP

Refer to the exhibit. Which feature is enabled by this configuration?

A. static NAT translation B. a DHCP pool C. a dynamic NAT address pool D. PAT

Which NAT term is defined as a group of addresses available for NAT use?

A. NAT pool B. dynamic NAT C. static NAT D. one-way NAT

Which command can you enter to allow Telnet to be supported in addition to SSH?

A. transport input telnet ssh B. transport input telnet C. no transport input telnet D. privilege level 15

Refer to the exhibit. After you apply the given configuration to a router, the DHCP clients behind the device cannot communicate with hosts outside of their subnet.
Which action is most likely to correct the problem?

A. Configure the dns server on the same subnet as the clients B. Activate the dhcp pool C. Correct the subnet mask D. Configure the default gateway

Refer to the exhibit. Which rule does the DHCP server use when there is an IP address conflict?

A. The address is removed from the pool until the conflict is resolved. B. The address remains in the pool until the conflict is resolved. C. Only the IP detected by Gratuitous ARP is removed from the pool. D. Only the IP detected by Ping is removed from the pool. E. The IP will be shown, even after the conflict is resolved.

Which command can you enter to determine the addresses that have been assigned on a DHCP Server?

A. Show ip DHCP database. B. Show ip DHCP pool. C. Show ip DHCP binding. D. Show ip DHCP server statistic.

What is the authoritative source for an address lookup?

A. a recursive DNS search B. the operating system cache C. the ISP local cache D. the browser cache

Which command is used to verify the DHCP relay agent address that has been set up on your Cisco IOS router?

A. show ip interface brief B. show ip dhcp bindings C. show ip route D. show ip interface E. show interface F. show ip dhcp pool