Win IT Exam with Last Dumps 2024

Which two statements about exterior routing protocols are true? (Choose two.)

A. They determine the optimal within an autonomous system. B. They determine the optimal path between autonomous systems. C. BGP is the current standard exterior routing protocol. D. Most modern networking supports both EGP and BGP for external routing. E. Most modern network routers support both EGP and EIGRP for external routing.

You have two paths for the 10.10.10.0 network - one that has a feasible distance of 3072 and the other of 6144. What do you need to do to load balance your EIGRP routes?

A. Change the maximum paths to 2 B. Change the configuration so they both have the same feasible distance C. Change the variance for the path that has a feasible distance of 3072 to 2 D. Change the IP addresses so both paths have the same source IP address

DRAG DROP - Drag each route source from the left to the numbers on the right. Beginning with the lowest and ending with the highest administrative distance. Select and Place:

Which two circumstances can prevent two routers from establishing an OSPF neighbor adjacency? (Choose two.)

A. mismatched autonomous system numbers B. an ACL blocking traffic from multicast address 224.0.0.10 C. mismatched process IDs D. mismatched hello timers and dead timers E. use of the same router ID on both devices

Which three describe the reasons large OSPF networks use a hierarchical design? (Choose three.)

A. to speed up convergence B. to reduce routing overhead C. to lower costs by replacing routers with distribution layer switches D. to decrease latency by increasing bandwidth E. to confine network instability to single areas of the network F. to reduce the complexity of router configuration

Refer to the exhibit. If R1 receives a packet destined to 172.16.1.1, to which IP address does it send the packet?

A. 192.168.14.4 B. 192.168.12.2 C. 192.168.13.3 D. 192.168.15.5

Refer to the exhibit. On R1 which routing protocol is in use on the route to 192.168.10.1?

A. RIP B. OSPF C. IGRP D. EIGRP

Refer to the exhibit. Which Command do you enter so that R1 advertises the loopback0 interface to the BGP Peers?

A. Network 172.16.1.32 mask 255.255.255.224 B. Network 172.16.1.0 0.0.0.255 C. Network 172.16.1.32 255.255.255.224 D. Network 172.16.1.33 mask 255.255.255.224 E. Network 172.16.1.32 mask 0.0.0.31 F. Network 172.16.1.32 0.0.0.31

Refer to exhibit. What Administrative distance has route to 192.168.10.1?

A. 1 B. 90 C. 110 D. 120

Which value is used to determine the active router in an HSRP default configuration?

A. Router loopback address B. Router IP address C. Router priority D. Router tracking number