Win IT Exam with Last Dumps 2025

Refer to the exhibit. Which two commands when used together create port channel 10? (Choose two.)

A. int range g0/0-1 channel-group 10 mode active B. int range g0/0-1 channel-group 10 mode desirable C. int range g0/0-1 channel-group 10 mode passive D. int range g0/0-1 channel-group 10 mode auto E. int range g0/0-1 channel-group 10 mode on

Refer to the exhibit. An administrator is tasked with configuring a voice VLAN. What is the expected outcome when a Cisco phone is connected to the GigabitEthernet 3/1/4 port on a switch?

A. The phone and a workstation that is connected to the phone do not have VLAN connectivity. B. The phone sends and receives data in VLAN 50, but a workstation connected to the phone sends and receives data in VLAN 1. C. The phone sends and receives data in VLAN 50, but a workstation connected to the phone has no VLAN connectivity. D. The phone and a workstation that is connected to the phone send and receive data in VLAN 50.

Refer to the exhibit. Which action is expected from SW1 when the untagged frame is received on the GigabitEthernet0/1 interface?

A. The frame is processed in VLAN 1 B. The frame is processed in VLAN 11 C. The frame is processed in VLAN 5 D. The frame is dropped

Which command is used to enable LLDP globally on a Cisco IOS ISR?

A. lldp run B. lldp enable C. lldp transmit D. cdp run E. cdp enable

Which command should you enter to configure an LLDP delay time of 5 seconds?

A. lldp timer 5000 B. lldp holdtime 5 C. lldp reinit 5000 D. lldp reinit 5

In a CDP environment, what happens when the CDP interface on an adjacent device is configured without an IP address?

A. CDP becomes inoperable on that neighbor B. CDP uses the IP address of another interface for that neighbor C. CDP operates normally, but it cannot provide IP address information for that neighbor D. CDP operates normally, but it cannot provide any information for that neighbor

DRAG DROP - Drag and drop the benefits of a Cisco Wireless Lan Controller from the left onto the correct examples on the right. Select and Place:

When configuring an EtherChannel bundle, which mode enables LACP only if a LACP device is detected?

A. Passive B. Desirable C. On D. Auto E. Active

Refer to the exhibit. Which VLAN ID is associated with the default VLAN in the given environment?

A. VLAN 1 B. VLAN 5 C. VLAN 10 D. VLAN 20

Which two VLAN IDs indicate a default VLAN? (Choose two.)

A. 0 B. 1 C. 1005 D. 1006 E. 4096