Question 51
Which statement is correct when traffic is received from 10.10.10.4?
A. The traffic is counted and accepted
B. The traffic is counted and rejected
C. The traffic is only rejected
D. The traffic is only accepted
Question 52
What does the output of the show route forwarding-table command display?
A. The routing protocol databases in the Routing Engine
B. The inactive entries in the Routing Engine's routing table
C. The Routing Engine's forwarding table
D. The Packet Forwarding Engine routing table
Question 53
You are troubleshooting an issue and want to monitor syslog in real time. Which operational command accomplish this task?
A. Show log message
B. Monitor start message
C. Show log message | refresh 1
D. Monitor traffic interface fxp0.0
Question 54
Referring to the exhibit, which parameter at the end of the command would provide information for troubleshooting purposes?
A. No-timestamp
B. Extensive
C. Print-ascii
D. No-resolve
Question 55
What is the default route preference for OSPF internal?
A. 100
B. 150
C. 5
D. 10
Question 56
Which command produced the output shown in the exhibit?
A. Show interfaces summary
B. Show interfaces filters
C. Show interfaces extensive
D. Show interfaces terse
Question 57
While working on a Junos Device, you receive the message shown in exhibit, In this scenario, what would you do to stop the shutdown process?
A. Issue the clear system commit command
B. Issue the clear system reboot command
C. Issue the request system halt in command
D. Issue the request system power-off in command
https://www.juniper.net/documentation/en_US/junos/topics/reference/command-summary/clear- system-reboot.html
Question 58
Which statement is true?
A. Traps are allowed from 10.21.15.180
B. Traps are sent to 10.21.15.180
C. Traps are sent to 10.21.15.16
D. Traps are allowed from 10.21.15.16
Question 59
Which IP protocol number is assigned to TCP?
A. 4
B. 6
C. 18
D. 17
Question 60
Which two statements are correct about the request system zeroize local command? (Choose two.)
A. The command preserves the management interface addresses.
B. The command resets all key values.
C. The command removes all data files.
D. The command removes all user-created files from the system.
