Question 21
By default, the cost of an OSPF interface is calculated based on the bandwidth. The formula to calculate the cost is reference bandwidth/interface bandwidth.
A. TRUE
B. FALSE
Question 22
The route selection tool route-policy" can set and filter BGP attributes based on pre-defined conditions. Therefore, this tool is often used to define policies towards a BGP peer or during route generation.
A. TRUE
B. FALSE
Question 23
Which of the following route entries matches ACL 2001 that is defined below?1.0.0.0/8 ,1.2.0.0/16,1.2.3.0/24,1.2.4.0/24,1.2.5.0/24, 1.2.6.0/24,1.2.7.0/24,1.2.8.0/24ACL 2001:Basic ACL 2001, 1 rule -Ad's step is 5 -rule 0 permit source 1.2.1.0 0.0.254.255
A. 1.2.3.0/24,1.2.4.0/24, 1.2.5.0/24, 1.2.6.0/24,1.2.7.0/24,1.2.8.0/24
B. 1.0.0.0/8,1.2.0.0/16,1.2.3.0/24,1.2.4.0/24,1.2.5.0/24, 1.2.6.0/24,1.2.7.0/24,1.2.8.0/24
C. 1.2.3.0/24,1.2.5.0/24,1.2.7.0/24
D. 1.2.0.0/16,1.2.4.0/24,1.2.6.0/24,1.2.8.0/24
Question 24
The default-route originate command in the RIP protocol advertises a default RIP route to the peers. When using this command, which of the following attributes can be set for the default route?
A. Tag
B. Cost
C. Interface
D. Nexthop
Question 25
We can prevent a router from ever becoming a DR or BDR by configuring an OSPF Priority of zero,
A. TRUE
B. FALSE
Question 26
What command must be configured to establish a BGP connection between indirectly connected EBGP peers?
A. peer connect-interface
B. peer valid-ttl-hops
C. peer ignore
D. peerebgp-max-hop
Question 27
Which of the following elements are used by Network LSA to describe broadcast or NBMA network segments in OSPF routing protocol? (Select 3 answers)
A. Link ID
B. Net mask
C. Attached Router list
D. Metric
Question 28
Based on BGP route selection rules, how are Origin attributes listed in descending order of priority?
A. EGP > IGP > Incomplete
B. IGP > Incomplete > EGP
C. Incomplete > EGP > IGP
D. IGP > EGP > Incomplete
Question 29
Which statement regarding BGP is false?
A. BGP runs over TCP.
B. BGP is an enhanced distance-vector routing protocol.
C. BGP uses port number 189.
D. BGP is an inter-AS routing protocol.
Question 30
Which of the following situatbns will occur when the command multicast bad balance" is configured? (Select 3 answers)
A. If there exists no unicast equal-cost routes, multicast load balancing fails.
B. If group address-based load splitting is employed, balanced distribution of entries over equal-cost routes cannot be ensured due to hash function limitations.
C. Balanced distribution of entries over equal-cost routes can be ensured as long as multicast load balancing is performed.
D. During multicast load splitting, traffic may not be balanced among equal-cost routes because multicast load balancing is based on multicast entries not
