What is the route-tag setting in an SD-WAN rule used for?
Question 32
Refer to the exhibit. The exhibit shows the SD-WAN rule status and configuration. Based on the exhibit, which change in the measured latency will make T_MPLS_0 the new preferred member?
Question 33
Refer to the exhibits. Exhibit A shows the traffic shaping policy and exhibit B shows the firewall policy. The administrator wants FortiGate to limit the bandwidth used by YouTube. When testing, the administrator determines that FortiGate does not apply traffic shaping on YouTube traffic. Based on the policies shown in the exhibits, what configuration change must be made so FortiGate performs traffic shaping on YouTube traffic?
Question 34
Which are three key routing principles in SD-WAN? (Choose three.)
Question 35
Refer to the exhibit. Based on the output, which two conclusions are true? (Choose two.)
Question 36
Which two statements about SLA targets and SD-WAN rules are true? (Choose two.)
Question 37
What does enabling the exchange-interface-ip setting enable FortiGate devices to exchange?
Question 38
Which diagnostic command can you use to show the configured SD-WAN zones and their assigned members?
Question 39
Refer to the exhibits. Exhibit A shows the packet duplication rule configuration, the SD-WAN zone status output, and the sniffer output on FortiGate acting as the sender. Exhibit B shows the sniffer output on a FortiGate acting as the receiver. The administrator configured packet duplication on both FortiGate devices. The sniffer output on the sender FortiGate shows that FortiGate forwards an ICMP echo request packet over three overlays, but it only receives one reply packet through T_INET_1_0. Based on the output shown in the exhibits, which two reasons can cause the observed behavior? (Choose two.)
Question 40
Refer to the exhibit. Which two SD-WAN template member settings support the use of FortiManager meta fields? (Choose two.)