Question 71
A technician has been asked to check on a SAN. Upon arrival, the technician notices the red LED indicator shows a disk has failed. Which of the following should the technician do NEXT, given the disk is hot swappable?
A. Stop sharing the volume
B. Replace the disk
C. Shut down the SAN
D. Stop all connections to the volume
Question 72
Network connectivity to a server was lost when it was pulled from the rack during maintenance. Which of the following should the server administrator use to prevent this situation in the future?
A. Cable management
B. Rail kits
C. A wireless connection
D. A power distribution unit
Question 73
Which of the following access control methodologies can be described BEST as allowing a user the least access based on the jobs the user needs to perform?
A. Scope-based
B. Role-based
C. Location-based
D. Rule-based
Question 74
A datacenter technician is attempting to troubleshoot a server that keeps crashing. The server runs normally for approximately five minutes, but then it crashes.
After restoring the server to operation, the same cycle repeats. The technician confirms none of the configurations have changed, and the load on the server is steady from power-on until the crash. Which of the following will MOST likely resolve the issue?
A. Reseating any expansion cards in the server
B. Replacing the failing hard drive
C. Reinstalling the heat sink with new thermal paste
D. Restoring the server from the latest full backup
Question 75
A server administrator is exporting Windows system files before patching and saving them to the following location:
\server1\ITDept\
Which of the following is a storage protocol that the administrator is MOST likely using to save this data?
A. eSATA
B. FCoE
C. CIFS
D. SAS
Question 76
A server technician has received reports of database update errors. The technician checks the server logs and determines the database is experiencing synchronization errors. To attempt to correct the errors, the technician should FIRST ensure:
A. the correct firewall zone is active
B. the latest firmware was applied
C. NTP is running on the database system
D. the correct dependencies are installed
Question 77
A technician is connecting a Linux server to a share on a NAS. Which of the following is the MOST appropriate native protocol to use for this task?
A. CIFS
B. FTP
C. SFTP
D. NFS
Question 78
A server in a remote datacenter is no longer responsive. Which of the following is the BEST solution to investigate this failure?
A. Remote desktop
B. Access via a crash cart
C. Out-of-band management
D. A Secure Shell connection
Question 79
A server is reporting a hard drive S.M.A.R.T. error. When a technician checks on the drive, however, it appears that all drives in the server are functioning normally. Which of the following is the reason for this issue?
A. A S.M.A.R.T. error is a predictive failure notice. The drive will fail in the near future and should be replaced at the next earliest time possible
B. A S.M.A.R.T. error is a write operation error. It has detected that the write sent to the drive was incorrectly formatted and has requested a retransmission of the write from the controller
C. A S.M.A.R.T. error is simply a bad sector. The drive has marked the sector as bad and will continue to function properly
D. A S.M.A.R.T. error is an ECC error. Due to error checking and correcting, the drive has corrected the missing bit and completed the write operation correctly.
Question 80
A server administrator has been creating new VMs one by one. The administrator notices the system requirements are very similar, even with different applications. Which of the following would help the administrator accomplish this task in the SHORTEST amount of time and meet the system requirements?
A. Snapshot
B. Deduplication
C. System Restore
D. Template
