Refer to the exhibit. If router A is the RP, which PIM mode can you configure so that devices will send multicast traffic toward the RP?
Question 172
Refer to the exhibit. Which statement supports QPPB implementation?
Question 173
Why do packet loops occur during the configuration of BIDIR-PIM?
Question 174
A network engineer is implementing a QoS policy for outbound management traffic classification and marking on a CPE device with these requirements: - Management protocols must be marked with DSCP AF class 2 with low drop probability. - Monitoring protocols must be marked with DSCP AF class 1 with low drop probability. - All remaining traffic must be marked with a DSCP value of 0. Which configuration must the engineer implement to satisfy the requirements?
Question 175
What occurs when a high bandwidth multicast stream is sent over an MVPN using Cisco hardware?
Question 176
A network operator needs to implement PIM-SSM multicast configuration on a customer's network so that users in different domains are able to access and stream live traffic. Which two actions must the engineer perform on the network to make the streaming work? (Choose two.)
Question 177
Which protocol is used for communication between the PCE and PCC?
Question 178
A network engineer is configuring RIP as the routing protocol between multiple PEs and CEs. The engineer must avoid advertising the same routes back to their sources. Which action should be performed on the routers to accomplish this task?
Question 179
A network engineer is deploying VPLS configuration between multiple PE routers so that customer's remote offices have end-to-end LAN connectivity. Which additional configuration should the engineer perform on the PE routers to enable the virtual switch instance?
Question 180
The network-engineering team of a service provider is integrating several recently acquired networks into a more scalable common Unified MPLS architecture. The new network architecture will support end-to-end VPNv4 and VPNv6 services with these requirements: - The IGP of the core layer is IS-IS in Area 0. - The IGP of the aggregation layers is OSPF in Area 0. - The LDP protocol is used to distribute label bindings within each IGP domain. Which task must the network engineer perform when implementing this new architecture?
