Question 261
Refer to the exhibit. An engineer implemented CoPP but did not see OSPF traffic going through it. Which configuration resolves the issue?
A. control-plane service-policy input COPP
B. policy-map COPP class OSFP police 8000 conform-action transmit exceed-action transmit violate-action drop
C. ip access-list extended OSFP permit ospf any any
D. class-map match-all OSFP match access-group name OSFP
Question 262
Refer to the exhibit. R1 and R2 use IGP protocol to route traffic between AS 100 and AS 200 despite being configured to use BGP. Which action resolves the issue and ensures the use of BGP?
A. Configure distance to 100 under the OSPF process of R1 and R2
B. Remove distance commands under BGP AS 100
C. Remove distance commands under BGP AS 100 and AS 200.
D. Configure distance to 100 under the EIGRP process of R1 and R2
Question 263
Which table is used to map the packets in an MPLS LSP that exit from the same interface, via the same next hop, and have the same queuing policies?
A. LDP
B. FEC
C. CEF
D. RIB
Question 264
Which of the following OSPF Link State Advertisements (LSA’s) were created for IPV6 and do not apply to IPv4 OSPF networks? (Choose two.)
A. Link LSA (Type 8)
B. Summary LSA (Type 3)
C. Router LSA (Type 2)
D. Intra-Area Prefix LSA (Type 9)
E. Opaque LSA (Type 9)
Question 265
What TCP port is used by LDP to provide for reliable transport connections?
A. 646
B. 648
C. 752
D. 712
Question 266
Which of the following are control plane protocols used within a service provider MPLS network? (Choose two.)
A. OAM
B. RSVP
C. Targeted LDP
D. SNMP
E. LDP
Question 267
At which layer of the OSI model is an MPLS label imposed?
A. Layer 2
B. Layer 3
C. Between layers 2 and 3
D. Between layers 3 and 4
Question 268
Which of the following statements are true regarding the e IPv6 RA Guard feature?
A. This feature is support on LAG bundles interfaces
B. This feature is supported on private VLANs
C. Packets dropped by the IPv6 RA Guard feature cannot be spanned.
D. This feature offers protection in networks where IPv6 traffic is tunneled.
Question 269
First-Hop Security (FHS) is a set of features to optimize IPv6 link operation, and help with scale in large L2 domains. Which of the following are valid First-Hop Security features supported by Cisco? (Choose three.)
A. IPv6 RA Guard
B. IPv6 Source Guard
C. DHCPv6 Guard
D. IPv6 Snooping
E. DHCPv6 Snooping
Question 270
SNMPv2 has been used throughout a network to manage all of the network devices. You have been asked to migrate to an SNMPv3 solution instead. What is the biggest advantage to migrating from SNMPv2 to SNMPv3?
A. Enhanced security, including encryption of passwords
B. Enhanced performance, supporting more messages per minute.
C. Enhanced scaling, supporting thousands more devices per network segment than SNMPv2.
D. Using a push model instead of pull. SNMPv3 uses telemetry to push data to SNMP management stations in real time.