Win IT Exam with Last Dumps 2025

Which configuration command can you apply to a HSRP router so that its local interface becomes active if all other routers in the group fail?

A. no additional config is required B. standby 1 track ethernet C. standby 1 preempt D. standby 1 priority 250

Which two statements about eBGP neighbor relationships are true? (Choose two.)

A. The two devices must reside in different autonomous systems B. Neighbors must be specifically declared in the configuration of each device C. They can be created dynamically after the network statement is configured D. The two devices must reside in the same autonomous system E. The two devices must have matching timer settings

Refer to the exhibit. How will the router handle a packet destined for 192.0.2.156?

A. The router will forward the packet via either Serial0 or Serial1. B. The router will return the packet to its source. C. The router will forward the packet via Serial2. D. The router will drop the packet.

Which statements describe the routing protocol OSPF? (Choose three.)

A. It supports VLSM. B. It is used to route between autonomous systems. C. It confines network instability to one area of the network. D. It increases routing overhead on the network. E. It allows extensive control of routing updates. F. It is simpler to configure than RIP v2.

Refer to the exhibit. After you apply the given configurations to R1 and R2 you notice that OSPFv3 fails to start.

A. The area numbers on R1 and R2 are mismatched B. The IPv6 network addresses on R1 and R2 are mismatched C. The autonomous system numbers on R1 and R2 are mismatched D. The router ids on R1 and R2 are mismatched

Which two capabilities of Cisco DNA Center make it more extensible? (Choose two.)

A. REST APIs that allow for external applications to interact natively with Cisco DNA Center B. adapters that support all families of Cisco IOS software C. SDKs that support interaction with third-party network equipment D. modular design that is upgradable as needed E. customized versions for small, medium, and large enterprises

Refer to the exhibit. A network associate has configured OSPF with the command:
City(config-router)# network 192.168.12.64 0.0.0.63 area 0
After completing the configuration, the associate discovers that not all the interfaces are participating in OSPF. Which three of the interfaces shown in the exhibit will participate in OSPF according to this configuration statement? (Choose three.)

A. FastEthernet0 /0 B. FastEthernet0 /1 C. Serial0/0 D. Serial0/1.102 E. Serial0/1.103 F. Serial0/1.104

Refer to the exhibit. C-router is to be used as a "router-on-a-stick" to route between the VLANs. All the interfaces have been properly configured and IP routing is operational. The hosts in the VLANs have been configured with the appropriate default gateway. What is true about this configuration?

A. These commands need to be added to the configuration: C-router(config)# router eigrp 123 C-router(config-router)# network 172.19.0.0 B. These commands need to be added to the configuration: C-router(config)# router ospf 1 C-router(config-router)# network 172.19.0.0 0.0.3.255 area 0 C. These commands need to be added to the configuration: C-router(config)# router rip C-router(config-router)# network 172.19.0.0 D. No further routing configuration is required.

Refer to the exhibit. Which address and mask combination represents a summary of the routes learned by EIGRP?

A. 192.168.25.0 255.255.255.240 B. 192.168.25.0 255.255.255.252 C. 192.168.25.16 255.255.255.240 D. 192.168.25.16 255.255.255.252 E. 192.168.25.28 255.255.255.240 F. 192.168.25.28 255.255.255.252

Refer to the exhibit. Given the output for this command, if the router ID has not been manually set, what router ID will OSPF use for this router?

A. 10.1.1.2 B. 10.154.154.1 C. 172.16.5.1 D. 192.168.5.3